How to Install the Brightberry Suction Sticker on Stokke Tripp Trapp tray - Water Method

This instructional video demonstrates how to apply the Brightberry Suction Sticker to the Stokke Tripp Trapp tray using the water method. This method is ideal for transparent stickers applied to plastic surfaces.
Prewash: First, prewash the tray using soap and water. Thoroughly rinse off the soap. Dry the tray with a cloth, then use the included cleaning pad. Ensure the tray is completely dry before proceeding.
Apply Water: Apply water to the tray using a spray bottle or by pouring it on. The water allows you to adjust the sticker's position until it is in the desired location.
Position the Sticker: Once the sticker is properly positioned, press out any excess water from the centre to prevent bubbles from forming.
Remove Excess Water: After achieving the desired appearance, remove any remaining water and use a dry cloth to press out any trapped water. This process may take a few minutes, so be patient and ensure you push out as much water as possible. Firmly press down on the edges.
Smooth Out Bubbles: Use a plastic card wrapped in a soft cloth, such as a microfiber cloth, to smooth out any remaining air or water bubbles. Always work from the centre of the sticker towards the edges.
Seal the Edges: Use a clean cloth to press down firmly on the edges, removing any remaining water. Pay extra attention to the edges to ensure a secure hold.
Optional Sealing: For an even better seal, use a hairdryer to warm up the sticker for a few minutes. Then, use the plastic card wrapped in a soft cloth again to smooth out any remaining bubbles or excess water.
Congratulations! Your suction bowls and plates will now stay securely in place on the tray.
To purchase Brightberry Suction Stickers, follow this link:
brightberry.co...