HOW TO Install the GEN3 and Driveline!!!

[@chrisjacobs2314]

Will this shaft also work on 2018 xp1000 4 Highlifter?

[@jamieruble3329]

How can you grease a sealed bearing?

[@RcrBrent]

Good question, we have patented a proprietary seal which allows our bearing to be greased.

[@ICU-th7qj]

I assume this is the same for the 900s? I will also be changing the u joints

[@SandcraftRCR]

Give us a call @ the shop. 4805394438

[@sebastiancarter349]

Dude, that is a lot better install video than the previous ones that Sandcraft has put out. The others leave some room for figuring out and make some of the pain in the ass stuff look easy. This video was great! Have one for the XP4 Turbo?

[@SandcraftRCR]

Not yet!

[@ridewot]

Just installed the Gen 3 carrier bearing on my 2017 RZR1000 XP and you have to cut the shield where the carrier bearing mounts. It will not clear the new bearing

[@ICU-th7qj]

I threw my shield in the junk pile

[@Gebunkable]

thanks...well done

[@ICU-th7qj]

Is some of the gold ring suppose to show with the bearing fully on? Maybe a 1/16 th

[@rwr9687]

Is that a sealed bearing?

[@SandcraftRCR]

Yes, it has a triple layer seal.

[@wloyet]

It doesn’t look like any of the interior was removed for this installation. Is that true. Other videos show the interior completely removed, seats, center console etc. Can the OEM be removed and Gen 3 be installed from the underside only with the right tools?

[@SandcraftRCR]

Yes, it can.