How to load labels in your TSC DA210 or DA220 label printer

The TSC DA series printer clamshell design allows for easy label rolls.
Loading the Roll Labels :
1. Open the printer top cover by pressing up the top cover open tabs located on each side of the printer.
2. Separate the media holders to the label roll width.
3. Place the roll between the holders and close them onto the core.
4. Place the label leading edge onto the platen roller. (printing side face up).
5. Close the top cover gently and make sure the cover latches securely.
6. Use “Diagnostic Tool” to set the media sensor type and calibrate the selected sensor. (Start the “Diagnostic tool” Select the “Printer Configuration” tab Click the “Calibrate Sensor” button).
Note: * Please calibrate the gap/black mark sensor when changing media.
Loading External Media:
1. Open the printer top cover by pressing up the top cover open tabs located on each side of the printer.
2. Separate the media holders to the label width.
3. Press down the media holder lock switch to fix the media holder.
4. Feed the media through the rear external label entrance chute. (printing side face up) Place the label leading edge onto the platen roller.
5. Close the top cover gently and make sure the cover latches securely.
6. Use “Diagnostic Tool” to set the media sensor type and calibrate the selected sensor. (Start the “Diagnostic tool” Select the “Printer Configuration” tab Click the “Calibrate Sensor” button)
Note: * Please calibrate the gap/black mark sensor when changing media.
DA Printer Media Specifications:
Media roll capacity: 127 mm (5") OD.
Media core diameter: 1" (1.5") ID core.
Media type: Continuous, die-cut, black mark, External fan-fold, receipt.
Media wound type: Outside wound Media width 19 mm ~ 114 mm (0.7”~ 4.5”).