How to make a square hole to the metal plate

[@MAC-ez2rq]

This guys is a pro. Tnx for the tips.

[@petesmith9472]

Thank you. A lifetime hint right there.

[@Andrew-rc3vh]

I tend to do it so the holes are spaced just short of twice their diameter and then centre punch between them and drill.

[@miniwattnetwork8204]

man you blew my mind awesome idea thank you

[@CHB_98]

Great video will this work for Brass as well I need to make a square in a 3/32 brass piece (2.38)mm

[@kevinhoronzy6011]

What type of punch center, line-up?

[@BohumirZamecnik]

Thanks, I was looking how to make a half-open rectangle hole for a C-shape thick workpiece. The sides can be cut by hack saw but the inner edge needs to be drilled first.

[@sureshlingabathina]

Excellent

[@minpisarn01]

Thank you

[@FrankAustinLowney]

Filing should only be done in forward direction. Bi-directional use dulls the file.

[@comandornic440]

is it less than 2mm thick plate?

[@Yuēhàn24]

For very thin sheet you can just use the chisel no need to drill first especially on thin aluminium. great video.

[@MrCPPG]

I need to do this to 1/4 inch thick aluminum. Do you think a chisel alone would work?

[@euphonic922]

what is used used to scribe the metal and tap the little dents?

[@GenePavlovsky]

A scriber and a center punch, respectively.

[@wk961]

BRILLIANT!!!

[@aerofart]

This is a fine method for rough work, but not very good for precise or clean work.

[@juliogonzo2718]

Ok, how would you have done it with hand tools?

[@Silen725]

incredibile!

[@BCblackchicken]

Diky za tip, potrebuji udelat obdelnikove otvory do hlinikoveho profilu po T5 trubice pruchodky. Vim kde zacit. At se dari.

[@jvcute9515]

Godbless

[@zanastumasonis]

thanks

[@serfinusa9532]

i used a dremel

[@juaralampung6671]

There must be easier way than this. It is 21st century for sake

[@anonymousarmadillo6589]

Use a laser or waterjet cutter.

[@chroma6947]

If you cant simply use a chisel+hammer and then sand the edges i dont think you should even bother. Its not hard. Unless you have a cnc machine this is the easiest way imo.

[@nighthawk6468]

You could always use a dremel, a cut-off wheel, and a steady hand.

[@GenePavlovsky]

@@nighthawk6468 I've done it with a dremel, and the chisel&file method can actually be faster and less annoying.

[@nighthawk6468]

@@GenePavlovsky Yeah for sure, though filing can get a little annoying after a while though!