How to Make FLEX Sensor at Home | DIY Flex Sensor | Make Low-Cost Flex Sensor at Home in 10 Minutes

[@TechNuttiez]

Subscribe for more such content: kzbin.info

[@anrealnub2686]

i have a question, why do we shade the paper strip, is it because of the properties of the pencil?

[@sylarrobertjones]

Graphite is a high heat and electric conductive material

[@mhw-mr.helloworld4400]

I have another doubt, how do i connect this , I am currently using a nodemcu ESP 8266 12E . It only has one analog input.

[@TechNuttiez]

You can use the same method which we used to connect this in the video!

[@mhw-mr.helloworld4400]

@@TechNuttiez Is there any way I can connect it directly to the pin?

[@TechNuttiez]

@@mhw-mr.helloworld4400 please refer to the schematics and specifications of the components that you are using and then decide based on that!

[@mhw-mr.helloworld4400]

This is very amazing brother but does it sense how much the sensor is being bend or is it just on/off ?

[@TechNuttiez]

It gives a value between 0 and 1023 depending on the bend!

[@mhw-mr.helloworld4400]

@@TechNuttiez What if connect another wire on either of the sides , can I use it like a regulator. I am using it for a project on my channel. Your opinion would be really helpful thankyou

[@TechNuttiez]

@@mhw-mr.helloworld4400 Yes, I think this is completely possible!

[@user-n917]

What is red wire black wire?

[@brainstormz3779]

Remember the flex sensor building trials which we performed? 😂😂

[@TechNuttiez]

Yeah they surely contributed a lot to this final model 😆

[@harshalshah5628]

Op bolte 🔥

[@TechNuttiez]

🙏

[@SpectraSymbolTeam]

Touche'... well if you ever want to come back and get one that'll last 1 million bends... we're always here for you. :) Also... we launched our next-gen flex sensors, the "SpectraFlex" at an even cheaper price than before due to new improved manufacturing methods. Check em out!

[@zekicordell1498]

can this bend in the other direction? because the flex sensor can only bend in one direction

[@SpectraSymbolTeam]

You are correct that ours 'prefer' to be bent on one direction for best results. (away from resistive layer, or the striped side)

[@kaiwei2263]

Bro, I followed ur step but my flex sensor works a bit different from urs. My flex sensor decrease resistance value while bend. May I know what’s wrong. I think I’m too stupid for this.

[@yertaybeats7115]

try to switch ground and 5V pins on your breadboard that should work

[@Sivan20065]

Same😢

[@ahmadnadeem5256]

Is it work same as flex sensor work any issue?

[@TechNuttiez]

Works like that.

[@roin7958]

thx bro u made my day

[@TechNuttiez]

Glad we could help!

[@michaelrtreat]

Brilliant

[@amareshkaturi9136]

❤️🔥🔥

[@TechNuttiez]

🙏

[@Arhocks]

I'm trying to do this, but while testing the paper, the electricity don't go through the paper, why is this, my pencil is made with graphite if it matters.

[@thedev6172]

#diyiscool