This design works with all LED lights. You don't need to buy a backlight driver because it's easy to do.
Пікірлер: 13
@tinaarroyo397 Жыл бұрын
Thanks for the idea.
@dumbamus Жыл бұрын
How do you connect on tv
@freafernandez3853 Жыл бұрын
Thank you lodz
@mattmotto5612 Жыл бұрын
Tnx for sharing
@celsoasilo76810 күн бұрын
Medyo madilim bos
@sagaladioprek4 ай бұрын
dioda bright how much Ampere..?
@alommaxelectronicsshop4 ай бұрын
You can get that in your scrap crt tv. Board. You can use 1 amper
@thokozanizulu418310 ай бұрын
How do u switch off when tv it switch off .
@alommaxelectronicsshop9 ай бұрын
Just put 12 volt relay. You can get 12 volts from the tcon board fuse or panel board.
@johnjames852893 күн бұрын
Its good if you connect it from your tv power switch.when you turn on your tv, the led driver will turn on too..then the output of your led driver will be connected to the led backlight of your tv...
@nimalperera54549 ай бұрын
You explained how to make the driver, but you did not show us where to connect the output from the driver to the TV. What's the point? We can of course dance to your music without learning how to connect the driver to the TV. You did not explain how to give power to the driver? Is it as a separate connection in addition to the power supply to the TV? What's the point of your lesson?
@alommaxelectronicsshop9 ай бұрын
If you do not understand, you can contact me @ adonis_belnas@yahoo.com so that I can give you a diagram of this project
@johnjames852893 күн бұрын
If you are knowledgeable about electronic cktry you will know where to connect it,,, You should connect the ouput of this driver to the input line of your tv led backlight.. maybe it helps you alot..