guys a few tips for this type of AC to DC circuits. always add n inpur spike capacitor along with a bleeding resistor to absorb initial spike or your home power supply will short. second whatever you do. DO NOT add regular traces between AC and LM ALWAYS use planes or after a few uses it wwill start heating badly and last an third, ALWAYS ALWAYS ALWAYS add a fuck tonne of small hole vias on top and bottom ground planes to make sure all the current passes through easilt, the totall current density is even across the board and it also reduces stray capacitances and inductances as well.
@diwakarmr912410 ай бұрын
NICE
@mirceacluj2 жыл бұрын
Am descarcat si eu librarii de piese de pe siteul kikcad..dar nu stiu cum sa le iau in program .ADD library ..new libraries si nimic Problema mea este ca nu pot vizualiza componentele in 3d view. Doar footprints merge
@jaikrish503 ай бұрын
can you make a esp32 pcb design with development kit board with dht11 and relay with lcd display pcb board to monitor a temperature
@eleobo3 ай бұрын
kzbin.info/www/bejne/pJLMdIR9fcSmaJY
@thingsgood9596 Жыл бұрын
I added the footprints for all the components but components c1, c2, j1, j2, LED did not accept the footprints and is displaying error on the pcb layout. How do I correct this?
@eleobo Жыл бұрын
I found the all footprint from snapeda
@thingsgood9596 Жыл бұрын
@@eleobo okay. how do you autoroute in kicad
@MassimoG7 ай бұрын
You forgot 100nF capacitors IN and OUT.
@vetoyoganza61182 күн бұрын
WHERE SHOULD IT BE PLACED ?? CAUSE I FOUND ERROR IN INPUT LM 7805 BATTREY