How to perform an EasyCal calibration with the Liquiline CM44P transmitter

Additional Information: The lamp voltage has been changed to 10 V with Software version 1.06.03-0023 (2017-01-20) of Liquiline CM44P.
The UV sensor OUSAF44 can be easily calibrated with the EasyCal. This video shows the calibration routine with the Liquiline CM44P transmitter.
Lamp replacement for OUSAF44 UV sensors with Liquiline CM44P transmitter:
• Lamp replacement for O...
Optical filter replacement for OUSAF44 UV sensors with Liquiline CM44P transmitter:
• Optical filter replace...
More technical videos for Liquid Analysis:
• Technical support - Li...
OUSAF44 website:
eh.digital/2Ar...

[@iheartjorge1]

Hi question, at the end of calibration, the video shows that you pressed ok which took us to "Calibration is finished. (Hold will be disabled)" if "Ok" is not pressed could the hold condition be left on? or if instead of pressing OK when "Calibration is finished" prompt is displayed and we instead press ESC, will the hold condition remain?

[@veoteveo1]

too bad your not using LED technology...no filters needed....no heat up needed.....no uv lamp!....no drift.....cheaper and better....