Great sight! I’ve got mine dialed in 20-50 yards and getting ready to put my tape on it tonight. Thinking about buying a second sight for my daughters bow!
@qvfireman1582 жыл бұрын
How do you adjust the 1st, 2nd, and third axis? would be nice if it came with instructions.
@christopherphelps3424 Жыл бұрын
You can use an Allen to move your pins but if your sight was put on correctly the distances between your pins should be pretty dang close to the correct gap to sight top pin at 20 and bottom should fall close to 50. Now this also depends on draw weight, arrow weight etc. I have had the wheel to were the needle I will use to adjust longer shots at the very bottom so when I’m shooting past 50 yards I can raise the whole sight by loosening the red small adjustment which then allows you to turn the large knob to desired yardage. Then tighten back down the red adjustment. There are two more adjustments you can use for left or right. I would not worry bout that until you get vertical pins dead on the money. I was taught by one of the best shooters I know (Travis turner) to always shoot at a horizontal line first. When you are hitting the horizontal strip every time you know your up/down is dead money. Now you can make adjustments left/right. Obviously your sight could be slightly off and you not know it at 20-30 or even 40 yards. But as you back up to 40-50 yards this is we’re you will see the biggest difference. Because I am only 27.5 draw length and I’ve decided only pull back 65 lbs with a 480 g arrow I did have to make a small adjustment with with 50 pin by moving it only. Had I moved the whole housing to get 50 dead on which I tried I was high with my 20-40 pin. If I was shooting 70lbs it would have been money. So I reset housing dead on at 20-40 and the. Readjusted my 50 pin by moving it only. It’s now dead on. I’m now about to measure and figure out which out which tape I need to put on my sight. Hope that answered your question 2:48
@Thwacks_N_Backstraps4 жыл бұрын
I don't understand. 30 would be the top pin and not the bottom no?