Рет қаралды 651,758
Today I would like to share with you how to propagate pothos to get a new luxuriant and round pot like a professional gardener.
You choose the branches of pothos that have just switched to cow state to choose for breeding.
You cut the pothos branch, leaving the root part about 2 or 3 axillary leaves, so that the new growth can be stout.
After cutting the pothos branch from a mature tree, I now prepare a pot of soil for the cutting. Soil used for cuttings is very important, mate, porous but must be rotten, no longer hot, because otherwise the cuttings will not take root, but will also turn yellow.
Just press the ground tight enough for your hand.
I drenched it with water, then set it aside.
Turn over to cut the cuttings.
Each stem cutting has 1 axillary is fine, or 2 axillary is fine.
This part is too young, please skip it.
Cut to fit on the leaf axils a little, to prioritize pin into the soil to be longer.
To pin all of these pothos branches into the pot, you should start from the center of the pot, or from the edge of the pot.
I tried the case of pin from the edge of the pot, see if you should or not.
It looks very messy, and if you accidentally can't divide to pin branch, the middle of the pot will be empty, looking at the cutting pot is not very nice and even if it grows up, it will not create a beautiful pot.
And the way to plant from the center of the pot is the most suitable, the branch you plant enough to encroach on the edge there, how many branches you have, you can also adjust the round pot.
With these pin branches, most of them only have 1 axillary leaf, later each branch will come out 1 stage, the leaves will go up at the same time and from the same position, right in the pot, will make your pot look very beautiful.
Now you spray water over the plant once. Then you put the plant in a cool place, water this row for the potted plant.
Thank you for watching and sharing.
Wish you have a pot of plants like you want.
Best regards,