How to quickly program a Paradox Alarm with MG5050 and K10H

[@ferelsonar1768]

Hola! Cómo estás? Sabrás como activar el pitido durante el tiempo que uno tiene al ingresar a la casa para poder desactivar la alarma antes que suene la sirena? Osea antes cuando ingresaba a mi casa hacia el pitido en cuenta regresiva para recordarme que tengo que desactivar la alarma. Ahora no se por qué no me hace el sonido de cuenta regresiva cuando ingreso a mi casa. Ojalá puedas ayudarme tengo un teclado Parafox sp4000. Muchas gracias

[@Wayne-xy6yw]

Our Alarm started beeping in the night with error code 8 which would not clear. I disconnected the battery-which later tested ok at 13.7 V -and pulled the fuse on the control box to turn off all power to the unit but it still continued to chirp for quite some time -at least till I feel asleep -and then in the morning when I powered it up again it started chirping again with error 8 back again but when I cleared the error code it stopped chirping and error code 8 did not return. Any ideas as to why it would still chirp with the control Box powered off and what was going on ?

[@CJ-vg4tg]

Thanks - useful video. I have a sp6000. I want to change the delay of an existing set up exterior sensor #10 to instant as there is a delay currently. I believe this is code ´08´ looking at Chapter 7 in the manual. So if I understand correctly the sequence would be: Enter-0000-010(zone)-08(zone definition)-1(partition). ? Will it ask me about the part at the end for the EOL resistors selection event thought they are already set up? Thanks

[@bradthesparky91]

it should not. it should simply work as per your statement.

[@CJ-vg4tg]

@@bradthesparky91 perfect thanks. How do I exit the programming mode without making any changes? Just want to check if the installer code hasn't been changed first. Cheers

[@CJ-vg4tg]

entered Enter followed by 0000 or 000000 and the panel just emits a long beep at me and does nothing. I assume the installer has changed it then? I bet they are not willing to give it to me and I´ll have to reset everything!!@@bradthesparky91

[@bradthesparky91]

unfortunately yes you would have to reset and reprogramme the system. @@CJ-vg4tg

[@MrStelliTsA]

I wanna change the psw but i have 4 doors i dont remember which position is it. How to find it?

[@WordOnTheStreetOfficial]

Hey Brad! What does it mean when the buttons 1, 2, 3 and stay button are flashing

[@AngelMichael685]

Paradox από τον Καναδά

[@AngelMichael685]

Enter 0000 από το εργοστάσιο ο κωδικός