How to Rebuild a Keihin FCR Carburetor

[@rmatvmc]

Tusk Mid-Body Carburetor Gasket Kit: rmatvmc.link/tusk-carburetor-mid-body-gasket-kit Tusk Carburetor Rebuild Kit: rmatvmc.link/tusk-carburetor-rebuild-kit

[@emmanuelgonzalez-jk7mk]

Which ultrasonic cleaner do you guys use?

[@rmatvmc]

@@emmanuelgonzalez-jk7mk It is a VevorHome Ultrasonic Cleaner 5gal. We chose the 5gal so we could put engine cases in it. But you can get smaller if that's what you choose.

[@emmanuelgonzalez-jk7mk]

@@rmatvmc thanks for the fast response. Love the videos

[@emmanuelgonzalez-jk7mk]

@rmatvmc what solution do you use and what's the solution to water ratio?

[@rmatvmc]

@@emmanuelgonzalez-jk7mk We use simple green and water with a 1:10 ratio, at 105f temp so the parts you put inside don't discolor.

[@nighthawkj30A4]

Finally a Video on Keihin carburetors.

[@nighthawkj30A4]

Also Honda sells all the gaskets separate. They do have a kit but expensive and don’t come with all the gaskets. Nice to see tusk has it

[@ianjones7486]

Great video and appreciated. Time to rebuild mine tomorrow.

[@rmatvmc]

Thanks for watching! Let us know if you have any questions.

[@tbonesixtynine]

Great tutorial! Just a little question, I saw some other movies on this topic where someone said the grease to make the new gaskets sticky was best petroleum based so it would dissolve better in the fuel. Whats your opinion on this?

[@kerm9807]

Top of the range team 🎉

[@Benny_blanco85]

Awesome Video!

[@matthewthomason8524]

How would I fix the accelerator pump hitting the side of the carb instead of shooting down the throat? I haven’t seen any information anywhere to fix it!

[@danjacobs4192]

What ultrasonic cleaning solution are you using?

[@rmatvmc]

Simple green and water. somewhere around a 1:10 ratio, 105 F on the temp. If you don't already know, the tank usually heats up with use so starting at 105 doesn't let the tank get hot enough to discolor/chalk the aluminum. -Charles

[@daveyriendeau210]

Thanks for the video, big help. Bought a project bike, someone had monkeyed with it big time and taking my time going through it. Do you have any procedures for resetting the throttle position sensor? 05 KX250f

[@rmatvmc]

We have a video coming soon on how to set the tps, keep an eye out for it!

[@TheKinkedwhale]

Tps's are set using ohms so if you touch the connectors with your multimeter prongs and adjust the TPS it'll change the ohms, then it's just a matter of checking the manual for the correct ohm reading and setting it there

[@Van_pic]

I put a new fuel mixture screw in and the spring was very stiff and I tightened it a little too much and it pull the threads out. Do you know anywhere I can buy the middle part of the body or what I should do?

[@rmatvmc]

Dang that sucks! Sadly your best bet would be buying a whole new carb.

[@tobpitbull]

One of the most important things you missed, setting the TPS.

[@rmatvmc]

We have some videos coming out on how to clean and adjust the TPS, so be watching for those.

[@TrikeBikeAustralia]

Great Video !

[@rmatvmc]

Thank you! Glad you liked it. Thanks for watching and the feedback.