HOW TO REMOVE A CRANKSHAFT FROM JUST ABOUT ANY 2 STROKE ENGINE

[@colingraham5812]

Nice one again. The heat and freezer trick definitely works. Used to do it in the UK when fitting new wheel studs to the hubs on our coaches.

[@heavysnow8616]

Great job MM1. Always nice to watch what you have going on. Have a great day my friend!

[@joski9030]

You can make a simple puller from threaded bar two washers and two sockets but each to their own, some just love backyard ways don't dey Cletus.

[@THEMOWERMEDIC1]

Crank was junk cledus

[@nsalinas30]

Can you do a video on how identify if u have a bad crankshaft seal and fly wheel seal

[@jamesluecke3383]

Thank you mower medic

[@bumpkinrocks]

I love my Husqvarna replica case splitter works amazingly on my chainsaws

[@THEMOWERMEDIC1]

Me too I got mine from HL supply

[@timbercasing-kn9jt]

The crankshaft case is made of aluminum or cast iron?

[@anthonylopez4729]

How did you remove the cover of the crank shaft before starting the video?

[@exinanition2307]

THEMOWERMEDIC1, I am looking to find a set of torx bits such as the one you used in this video. Could you steer me in the right direction, please? I need some bits that will not twist in two when confronted with a tight or stuck screw. Thank you. I am also repairing a backpack blower the owner bought thinking it had a 4-stroke engine. He had been running straight gasoline in it until it seized up. I cut the cylinder off and removed the piston, wrist pin, and wrist pin bearing and am going to replace them.

[@Jim-ie6uf]

Sweet

[@johnkosheluk1041]

That is easy if it is brand new

[@j.m.5995]

Is there any way to separate the connecting rod from the crankshaft

[@THEMOWERMEDIC1]

Cutting torch

[@jme36053]

You’re gonna change the crankshaft oil seals too, right?

[@THEMOWERMEDIC1]

Absolutely

[@ncrdisabled]

how did that crank get messed up?

[@THEMOWERMEDIC1]

kzbin.info/www/bejne/l5OcnKx7Yr6emqM

[@robertyearian227]

The spot on crank shaft where the flywheel key goes messed up

[@eltonpham2165]

Then how do you remove crankshaft bearings?

[@THEMOWERMEDIC1]

This video is about crank shaft removal