How to remove and install a Keiser M3 Series belt

Applies to all M3/M3i Indoor Cycles and Total Body Trainers
Tools & Materials Required:
• Keiser Belt Service Kit (Bike PN 550824, TBT PN 550891)
• #1 and #2 Phillips Screwdrivers
• Tape
• Cutters
Additional Tools for TBT Models: 17 mm Wrench, 6 mm Allen Wrench
For further assistance, visit www.keiser.com...
⚠ DISCLAIMER:
While KEISER Corporation strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All service or maintenance procedures entail some risk. It is the sole responsibility of the viewer to assume this risk. KEISER Corporation is not responsible or liable for any loss, damage, (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@george2036]

Great video / step by step instruction. Only I didn't get the tools shown or one of the tools (the thing that goes onto the pedal shaft) was too short. Furthermore this is probably the 10th video take...long story short I got the new belt onto the bike and my problem was solved (crackling sound). New and old belt look the same so I was surprised when swapping them out made a difference.