I had been looking for detailed videos like this one ! Thanks a lot!
@raiderman285 ай бұрын
i wish you would have shown the rest of the repair. excellent content that many people want to see. i repaired one myself not knowing what i was doing, and it came out pretty good
@jocventura7804 ай бұрын
Well done .one cuestion pin # 6 are connected with the swich wires i mean continuited
@buttercupaz17 ай бұрын
Excellent video, thank you.
@Taner.durannАй бұрын
Hello, how were you able to remove the large plastic gear on the cable entry?
@luisr102 Жыл бұрын
Thanks bro!
@papalangham Жыл бұрын
nice work G
@nemzrepairs Жыл бұрын
Thanks 💯
@graythomason96428 ай бұрын
How did you disconnect the electrical cable, I can't find the connection to separate it from the harness
@tooedwin63964 ай бұрын
Wondering too
@athanasiosbellos3367 Жыл бұрын
hello again sir, finally i will try to rewire my throttle body . can i ask you what kind of wires should i use ? (i am newbie) thanks for your time , keep good work :)
@nemzrepairs Жыл бұрын
Use same gauge as the ones in throttle
@athanasiosbellos3367 Жыл бұрын
@@nemzrepairs i read in a post , black is 18 gauge and all the others 20 gauge . cause i dont know from wires , awg is the correct type ? thanks again you are a very fast replier :)
@athanasiosbellos3367 Жыл бұрын
Nice work mate . Can i ask you what type of connector will you use and how can i find it . I would like to do the same on mine throttle body. Thanks.
@nemzrepairs Жыл бұрын
I used a Bosch DT from Amazon
@athanasiosbellos3367 Жыл бұрын
@@nemzrepairs Thank you sir , you are amazing . Can i have any serial,link ?
@nemzrepairs Жыл бұрын
@@athanasiosbellos3367 amzn.to/40i9CZS
@athanasiosbellos3367 Жыл бұрын
You change both sides (male-female) the connectors ? In throttle body and main wirring harness?
@nemzrepairs Жыл бұрын
@@athanasiosbellos3367 yes the engine harness was in bits too
@mustaphaelkouaa462 Жыл бұрын
hellowe my brother where you living
@nemzrepairs Жыл бұрын
Ireland
@leo.portes6 ай бұрын
where did you find the eight pin connector to replace? I'm not getting
@nemzrepairs6 ай бұрын
Amazon bro
@zeejay8327 Жыл бұрын
How you remove that wheel with teeth?
@nemzrepairs Жыл бұрын
I didn’t remove the wheel you just have to solder under it skilfully try it it’s but if a pain