thank you. im swapping the mount on my trolling motor and instead of making the mount a nice easy clamp. i have to take the entire head and wiring apart.
@rjguess Жыл бұрын
Glad my video helped. Thanks for watching.
@mtnwayadventures9661 Жыл бұрын
Link to the next video?
@rjguess Жыл бұрын
kzbin.info/www/bejne/mXnQap2Vm85-b9k
@es64325 ай бұрын
Hello, What is the size of the 7th screw? I went fishing and realized once I put the boat in water that I lost this screw.
@rjguess5 ай бұрын
I cannot give you the answer. I am sorry. I no longer have this trolling motor. If I did, I would definitely give you the answer. I hope you eventually find out what size it is.
@55project Жыл бұрын
Another Great video, Thanks,. But for a quick tip, Tell folks to PRE Check the running of the trolling motor before pulling it apart. Because if you rip it all apart and find out it's not working , You may be stuck with it. ;)
@rjguess Жыл бұрын
Thanks. I appreciate your comment. Thank you for watching.
@luciarodriguez3891 Жыл бұрын
How you took off the telescoping handle? I have been trying to removed to putting back in the box 🙃
@rjguess Жыл бұрын
Well, it wasn’t installed on my unit. It came separated in the box. I wish I had an answer for you but I do not.
@McMike10001 Жыл бұрын
did you use same gage wire from that plug and receptacle on the back of your kayak to the controler or did you have to use a bigger gage ? also do you know what size gage the yellow, white, black, and red wires are? And where did you get that 4 pin plug from lol i want to do this same setup on my sea ghost
@rjguess Жыл бұрын
Yes, I kept all the wires the same gauge. I believe all the wires were 16 gauge. I tried to keep all the wires the same gauge as what was in the trolling motor. I ordered the 4 pin plug on Amazon. It’s fairly easy to do. Just a little time consuming. I hope you get this accomplished! Thanks for watching.