How to remove rear axle bearings! (Slidehammer + axle bearing puller) ⚒️⚒️⚒️

[@MichaelGietzen]

Look at the pictures at the end . The tool is only pulling on the cage on one side. The other side is pilling the rollers only. This can break the cage, leaving it in the rear end while blowing the rollers all over the place.

[@benjaminfuentes1618]

You did great job on showing that portion of the job, thank you.from Puerto Rico. Benjamin Fuentes

[@MegaFranceschini]

GOOD EQUIPMENT TO HAVE. GREAT IDEA. THANKS FOR THE TIP. HAVE A NICE ONE, TAKE CARE

[@Mike_The_Hog_A_Nator]

I have an 02' Blazer ZR2 w/ the 8.5" rearend & G80 Locker. I'm having a whining sound & it starts at 25mph & gets louder the faster you go. I thought it was my rear drivers side, but not! I rented one of those slide hammer pullers from O'Reilly for $109, then $70 for the bearing installer tool. I'm thinking i may need to tighten up my yoke because most of the noise is coming from my diff. I have zero in/out & up/down play in rear drivers side but i have in/out play in my passenger side rear. The G80 locker & everything inside the diff was nice and clean. No chips or shavings. I just cannot find this rear noise that started out sounding like a low power steering fluid noise, then got louder as the wheels roll. The yoke, u-joints, etc. are all tight & no leaks or clunking sounds. This has me scratching my head. lol

[@mg8718]

The only think i dont see in this kit is the small hook attachment for pulling your pilot bearing. The Lowes kit has them. It also gives to 2 different hub puller attackments.

[@gerdihalla5296]

Can you tell me what the kit is called at 1:32 minutes, also wants to change bearings

[@BGinsz1709]

Thank you! Awsome tutorial. Great vibes.

[@kcroc44]

I have a repair bearing that will not come out, even with the slide hammer. That sucker is stuck in there like it’s welded or something!!!!!! Any advice for that

[@darrinj7937]

Torch/apply a good amount of heat to the axle not the bearing itself, and try again.

[@decimation4u]

What year is your truck u did this on

[@aaronclark8877]

Any chance of some links to buy the tools

[@rickl8359]

I bought my kit on Amazon. Search for (rear axle bearing puller tool) and (slide hammer 9-way internal/external) and you need also a (seal installer bearing driver kit) to install the new bearing. I hope this help.

[@Houstonee1425]

Anyone that has done this on a chevy silverado 2016rwd ? Had an incident where the tire fell off the rotor from being jacked up and slided to the floor and the plate behind the rotors ended up on the floor and think it might’ve damaged my bearing since the truck feels wobbly like if the tire is going to fall off but its on there lug’d tight any insights?

[@ericg4915]

No link to the products?

[@chief8879]

Gearwrench

[@truthisweareallgonnadie.]

Otc 8piece comes with the slide hammer and all

[@zerogrim822]

Pittsburg jacks, clean fresh basically unused slide hammer and adapters…

[@INOMORETHNU]

Dana 60 157000 miles had to beat it like a redheaded step child. Not as easy as yours but all good!

[@Mariah7783-g9k]

I used these pullers and hammer ended up breaking both sides now I’m f$&@

[@truthisweareallgonnadie.]

Breaking what? Never had a problem with mine.