How to repair your STC 1000 if it’s not working or coming on

[@britesynth]

My coolinh thermostat is broken and wont close the circuit, I may have somehow shorted it while wiring the controller, cooling wont turn on, which piece do i have to replace?

[@Funhatch1198]

Will my best advice is to get a new one

[@tecnoduque]

Ive got a stc 1000 that constantly losea calibration. What would you start looking?

[@Funhatch1198]

First get a thermometer to check if the temperature is equal or is a bit off if so then use when you get from the thermometer to calibrate the Stc 1000

[@tecnoduque]

@@Funhatch1198 done that! But for no reason goes from.. 17° to 30° in 10 seconds, and later on that day might go back to 17°. Changed sensor, cables... I do know anymore

[@Funhatch1198]

Did you do the settings right

[@faroukdrisso]

stc 1000 does not turn off the power when reaching the highest level and continues heating. What's the solution please

[@mwasoteyohanbarakayohana1392]

Hey bro! My 12v controller it dosnt cool temp, so what can i do?

[@rubiebrabonga2846]

It is the same in stc 3028?not working/no power?what im going to do?

[@mtkkuluckaTuncay]

hello stc-1000 thermostat set button not working? I hold down the set button. But the parameter setting is not displayed!

[@Funhatch1198]

Looks like the button connections to the board is either it’s fault or there is a problem there so try and get an electrician to look at it

[@mtkkuluckaTuncay]

@@Funhatch1198 The set key works fine, I reset it and it didn't help. Should I look for the fault in the screen part or in the sub-circuit?

[@Funhatch1198]

Sub circuit

[@Funhatch1198]

But you do know how to set it right ?

[@microreniassance2929]

Hey, that was a fantastic video. However I have another problem which is my display on my stc-1000 keeps giving me a PP error or a P1 error and then it will turn on and run but it only runs one time. After that first initial run and cool down it stops running. Can you help me?

[@recipewithrazia]

Bro stc 1000 which resistance no. use my stc controller resistance is damaged which resistance i am used please reply

[@Funhatch1198]

10,000 ohms

[@mtkkuluckaTuncay]

I can't set the temperature value! how can i solve it?

[@Funhatch1198]

Ok

[@recipewithrazia]

Bro we have stc 1000 (12v) temperature controller His resistance is burnt which resistance should be put in it controller

[@Funhatch1198]

Somethings the resistance is different so send it to people who repair TVs and show it to them

[@zidnyknight3611]

Thanks

[@hanepbuhaytv8770]

i will try this