How to Replace Front Inner Tie Rod 2007-2013 Mitsubishi Outlander

Buy Now!
New Tie Rod from 1AAuto.com 1aau.to/ic/1AST...
This video shows you how to replace the inner tie rods on your 2007-2013 Mitsubishi Outlander. The inner tie rod has a ball joint that can wear over time, causing a clunking noise, loose steering, and eventually, other problems with the wheel and suspension components. It’s a good idea to replace your inner tie rods as soon as you notice any of these symptoms.
This process should be similar on the following vehicles:
2007 Mitsubishi Outlander
2008 Mitsubishi Outlander
2009 Mitsubishi Outlander
2010 Mitsubishi Outlander
2011 Mitsubishi Outlander
2012 Mitsubishi Outlander
2013 Mitsubishi Outlander
Tools you will need:
• 13mm Wrench 1aau.to/oIz/1AX...
• 19mm Wrench 1aau.to/oIz/1AX...
• 22mm Wrench
• 17mm Socket 1aau.to/oaVs/1A...
• 19mm Socket 1aau.to/oXi/1AX...
• Inner Tie Rod Removal Tool 1aau.to/oap/1AX...
• Pliers
• Ratchet 1aau.to/oa92/1A...
• Socket Extensions 1aau.to/oaVs/1A...
• Torque Wrench 1aau.to/oagb/1A...
• Liquid Thread Locker
• Marker / Writing Utensil
• Hammer 1aau.to/oI7/1AX...
• Pick 1aau.to/oBm/1AX...
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@rc4211]

At 2:10 the narrator said to count the number of rotations when removing the tie rod end, so that the new one can be installed using the same number of rotations. Just be aware that this only works if the replacement part is very close in length to the original part. If the replacement part is longer or shorter, the jam nut will need to be moved either in or out to some degree.

[@TRQ]

+R C Thanks for the tip! We'll pass this info along to our production team. 1aau.to/m/Shop-TRQ

[@nebhosspin1252]

Thanks for sharing

[@przemokbh8079]

hey nice video. I have ASX from 2017 its the same tie rod procedure? Can I change that without some special tools ? thanks

[@martinwinlow]

You are throwing the old ball joints away. Why bother protecting the thread with the nut?!!