√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*
@LowOutput3 жыл бұрын
Are those aftermarket headlamps and running/signal lamps? If so, are they parts you sell?
@johnypitman23683 жыл бұрын
I replaced this idle air control module on my 98 ck with 5.7 and it fixed my idle issues. My truck idled just fine until warmed up and then idled at about 1400rpm and that was a real pain of course. I used this video to show me how and it took me less than 1hr.
@jdinnis Жыл бұрын
A couple tips on these. First, you must make sure the pintle on the new valve is not out too far. For my truck (99 k2500 7.4l) the spec says 28 mm from the tip of the pintle to the flat mounting surface. If the new one is out too far you can gently push it in. A drop of oil on the the o-ring on install will make sure you don't pinch/cut it. The relearn procedure for the 98-99 trucks is key on for 5 seconds, do not start. Key off for 10 seconds. Done.
@1AAuto Жыл бұрын
+John Innis Thanks for the feedback!
@steveandrews83014 жыл бұрын
Just clean the piston in it with carb cleaner, put it back in, and it will usually work fine. - they're usually carboned up, dirty, is the problem. No need to buy a new replacement one.
@juanzarate2954 Жыл бұрын
I have a 99 chevy silverado that it idles at low rpm also the battery voltage drops to 10 and as soon as i gas it the battery voltage goes to 14. Any suggestions i thought about changing the IACV
@M3GAN31163 жыл бұрын
Do you need a torque the new idle control valve ?
@CentralCanada Жыл бұрын
Just tighten securely !
@Gkitchens14 жыл бұрын
Is there a relearn procedure?
@americanwhiteboy7153 ай бұрын
Is this part able to be reset
@jonbianchi26765 жыл бұрын
It would be nice to show the re learn process
@EataPeachMike2 жыл бұрын
there's a relearn process and do u know it?
@CentralCanada Жыл бұрын
Re-learn process ? My copy of "Haynes 24065" pg. 6-20, states; Install the IAC valve and tighten the screw(s), .....ooops can't share according to "All rights reserved/copyright" So can't potentially bring grief to 1A Auto !!
@jeffduncan25193 жыл бұрын
How do you know when that is bad on your car what are other signs
@williamclarkson70992 жыл бұрын
Really high idle
@zx0019614 жыл бұрын
I have a problem with a 99 Silverado runs good when it's cold once it warms up it runs like crap have no code 02 sensors are new A-1 Auto from you It's driving me nuts Fuel pressure is between 45 and 48 it might hit 50 like to know why it is missing so bad when it warms up can you help
@Franklinveterinarycenter1of4 Жыл бұрын
Cam sensor
@travistaylor2469 Жыл бұрын
What if when you start it it serges idle up and down then shuts off, but only stays running when applying throttle
@jacobhillanbrand79884 жыл бұрын
You guy are great. Great explanation
@1AAuto4 жыл бұрын
+Jacob Hillanbrand Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-1AAuto-c
@Lucky13tiki2 ай бұрын
Arent you suppose to do the reset procedure
@deeaguilar76452 жыл бұрын
My 97 gmc sierra wont go over 30 mph any suggestions?
@805BeachRecoveries2 жыл бұрын
Do rpms keep climbing but it won't go faster than 30? If so, it might not be shifting into the higher gears... might want to look into the solenoids in the transmission if that's the case
@dannelyssilva15713 жыл бұрын
How yo calibrar the pin?
@leswalker26394 жыл бұрын
I was wondering where that air flow sensor was answered my question thanks
@1AAuto4 жыл бұрын
+Les Walker Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c
@heartbeatstorm9836 жыл бұрын
Question.. Where is the idle control valve on a 1985 gmc sierra 1500 truck and does it even have one.???
@chevy85884 жыл бұрын
Shouldn't you disconnect battery?
@CentralCanada Жыл бұрын
Not according to Haynes #24065, pg 6-20 ; presumably disconnecting the electrical plug does the trick' !?
@KTHKUHNKK6 жыл бұрын
Hi guys I recently bought a bunch of front end parts from you guys and I'm very happy. I have a question now please. I just replace my IAC
@KTHKUHNKK6 жыл бұрын
I replaced my IAC on my 4.8 2000 GMC Sierra. But now it idles at 2000 RPM can you help me out with this problem. Thanks Keith Kuhn
@1AAuto6 жыл бұрын
+KEITH KUHN Hello, we aren't really able to diagnose vehicles like that. If you aren't sure what's wrong with it you can take it to a local mechanic for a proper diagnosis. Thank you! 1AAuto.com
@EataPeachMike2 жыл бұрын
@@KTHKUHNKK did u fix that issue and what was it? I have a 97 GMC that's doing the same thing
@davemcmurrick79626 жыл бұрын
Wow, looked like a rats nest in the back of the filter box.
@WildSuns424 жыл бұрын
So true, and that really should have been cleaned out
@9056aaron3 жыл бұрын
It would be nice if you showed that you put a new valve not the same one
@lesglover65152 жыл бұрын
Why does it matter? They showed you how to replace it I guess I don't understand why you need them to put a new one in?
@eliasvite73245 жыл бұрын
Chido chido
@onemichaelmarsee3 жыл бұрын
All those extra steps for nothing.
@1AAuto3 жыл бұрын
+Michael Marsee Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c