How to Replace PCV Valve 1995-2001 Ford Explorer

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@DiathenEridani]

Can you please start showing the locations? These videos start way zoomed in and sometimes its hard to locate the part.

[@c50truck]

Thank you for posting this. I suspected my 2000 Mountaineer had a bad PVC valve. It had all the classic symptoms. But the Haynes book was not helpful on a 5.0 engine. I followed your every step. Other than a couple skinned knuckles, I was successful, and at 146K, it's running fine again.

[@chevymontmarlo]

This can also apply to the Job 1 4.0 sohc found in the early 01 Sport Tracs which have two lines but the same PVC

[@TRQ]

+@chevymontmarlo Thanks for the feedback! 1aau.to/m/Shop-TRQ

[@DiathenEridani]

You need to zoom out once and a while so we can see where youre actually working. Show us the locations.

[@93aaronq]

Does this apply to an 2001 sport trac too?

[@CrackerFL]

I bought a Haynes manual. It showed where valve was supposed to be, but it wasn't. Will check where you showed. 147,000 miles and pcv never has been replaced. Running rough.

[@TekMan05]

Nice! Good to see some 5.0 content.

[@garymiller5132]

Outstanding video...thanks you helped me a lot

[@oscaroscuro]

what was the purpose of disconnecting the harness? was that just to have better access to the valve?

[@steveruegge5504]

Is this video for 5.0 or 4.0 or either?

[@subjecttochrist]

How did you get leverage to push it back in?? Man… pain in the forearm

[@Efren_montero]

thanks, I didn't know where it was and how to get out

[@RosettaRedfeather]

This does not match my Ford Explorer V6 4.0 L engine. I wish you would say which engine it was.

[@edgardomartinezroque5075]

Vine a ver la parte del video del min 233_234 pero fue muy rapido Tendre que mover a la velocity de la luz

[@subjecttochrist]

Literally worst angle ever to try to figure out where pcv valve is. That thing is a pain to reach

[@topdollar187]

Charlie Sheen

[@electric8668]

Makes no sense not to identify the engine being worked on.

[@subject2change]

Worst video ever wtf