Honestly, I recharged my motivation again by your video. thanks alot
@PredictableDesigns7 ай бұрын
Happy to hear that!
@diogocarvalho29347 ай бұрын
Could you make a tutorial on USB Power Delivery and ic's to use to configure it?
@ami6packs7 ай бұрын
Please make a video on can bus.
@fedimakni12007 ай бұрын
How the calculation will change if you fill the top layer with ground?
@PredictableDesigns7 ай бұрын
You would need to use a different calculator that includes a top layer ground plane. Same is true for an antenna feed line. Without top ground plane it's called a microstrip, but with top ground it's called a coplanar waveguide.
@rmatveev2 ай бұрын
It is very confusing to see the NC pins of the diodes assembly going out of the corners of the component. I'd avoid put pins in this way.
@PredictableDesigns2 ай бұрын
Not sure why that would be confusing and the pins are clearly labeled. Also this was the standard symbol for this part and I didn't draw it from scratch. Thanks for watching!
@rmatveev2 ай бұрын
@@PredictableDesigns it makes the schematic less readable for my opinion
@zviper7 ай бұрын
can i route other traces under the usb data lines on layer 3 or 4? not data just some 5v power and 3.3v pwm signal. The usb in my case is only needed during programming.
@PredictableDesigns7 ай бұрын
Yes that should be fine.
@Snowfats7 ай бұрын
thanks!
@tarasaurus247 ай бұрын
I’m routing usb signals today for the first time what luck this video came out this weeks 🥹