HOW TO SELECT SPRING FOR MOLD EJCTOR ASSM_ PART 1 BASIC REQUIREMENT.

[@Learn_123]

Sir make video of gas spring selection calculation and why they are used instead of coil springs?

[@Learn_123]

sir is there any calculations for selecting the diameter of RP??

[@SKCADCAMSOLUTIONS]

Not available any calculation ,but must check load from ejector assembly to decide Dia of Return pins.

[@Learn_123]

sir ejector pins are used to eject the part and ejector retainer pins are used to retain the ejector assembly(Safety of ejector pin)

[@final_destination_uk]

Pillar and guide bush मे कौन सी फिट होती है और इनके बीच कितना टोलरेंस होता है

[@SKCADCAMSOLUTIONS]

It must slide fit as per ISO STD tolerance. Keep Pillar g6 and Bush H7 🙏

[@final_destination_uk]

@@SKCADCAMSOLUTIONS sir I was asking tolerance in microns

[@SKCADCAMSOLUTIONS]

@@final_destination_uk it's different for each diameter. Pls refer std ISO tolerance sheet. You will get it on Google.

[@final_destination_uk]

@@SKCADCAMSOLUTIONS sir wedge block ka angle kaise decide aur calculation krte hn?

[@SKCADCAMSOLUTIONS]

@@final_destination_uk will make video soon