How to Setup and install Tasmota on ESP32

[@MrBobWareham]

Well that was easy can you do more videos on Tasmota working on its own, as everyone adds Home Assistant and I just want to use Tasmota, thanks Bob in the UK, Joined your channel in hope!!!

[@createinvent]

Thanks for the explanation. Very clear!

[@AlanBetancourt-i2s]

One question, how can I do the same but with a program of an ESP 32 with an ultrasonic sensor, I mean if with the same application you can configure the interface instead of showing off and on, it shows you the distance.

[@flyerminer]

I'm a bit new to ESP32 modules, and Tasmota/3rd party firmware like this is brand new to me. I have some experience programming with the arduino platform but I have a question for you. If I flash Tasmota to the ESP32 module, will I still be able to later program the ESP32 using the Arduino IDE? I just want to be sure I don't effectively brick my ESP32 if I load this onto the unit and decide later that I don't want to use Tasmota.

[@INOVATRIX]

Yes, Tasmota is just like any other code on the ESP32. You can use ARDUINO IDE afterwards to upload code without any trouble.

[@chrisw9499]

Nice vid, thanks !

[@bestonyoutube]

does this work on all esp32 dev boards? what about the pin configuration dont you need a supported template?

[@INOVATRIX]

I am using the ESP32 dev boards.

[@elitefdc2171]

can i combine it with wifimanager?