How to Sublimate a Neoprene Car Coaster Using a Heat Press | Sublimation Tutorial | DIY

[@FlipandFlutterCreations]

Hope you enjoyed learning how to make these easy neoprene car coasters! Don't forget to subscribe so you can check out my next tutorial! ❤📚🦋

[@thejoyofnorma]

Thank you for sharing what size did you do ?

[@Purebeachlove]

Do you have a video on how to ship coasters?

[@tammyrizzardi9611]

how do you stop from getting ghosting and blurs

[@FlipandFlutterCreations]

I tape them down with like 3 pieces of tape and try to lift gently when letting the press up.

[@laurieswain4239]

How did you do glitter

[@FlipandFlutterCreations]

The image in the background is a glitter purple. :)

[@taylorbeckler2236]

What app do u use for coasters when u print them???

[@FlipandFlutterCreations]

I use Photoshop.

[@sylviahofstra9547]

My are curling. Why

[@FlipandFlutterCreations]

You may have your pressure too much. Mine will do that if so. I put them under some heavy books and they are usually fine.

[@sylviabender7403]

I'd like to know sizes. What size is coasters and what size did you print.

[@FlipandFlutterCreations]

They are approximately 2.5" in diameter. I used their template and then just stretched my background about .25" extra. So my background us like 2.75". :) Hope that helps!

[@andrewdavidloch360]

4 inces... 10cm

[@brendabonk8711]

@@andrewdavidloch360 4 inches for what? I did 2.75 inches

[@meghanperdomo8269]

Do you seal it? Or it is all set?

[@FlipandFlutterCreations]

It's all set! No sealing! :)

[@valerierose6891]

What happens if you don’t prepress?

[@FlipandFlutterCreations]

Depends on what you are pressing. Sometimes I forget to prepress, and most of the time, it is fine. Sometimes, it will create an uneven press.

[@andrewdavidloch360]

Leftty LOOSEY Righty TIGHTIY as we say in Scotrland. We are engineers in Glasgow. 190 degrees Celsius for 65 seconds.

[@FlipandFlutterCreations]

Thanks!

[@paulacampos6311]

Sorry, I didn’t see the temperature you had it on