How To Tint John Deere 5075 Door

[@dbirdez]

Take a couple opaque pens and carefully cut open , drain into a small airtight container . Then you can use a small artist brush ( good one) and professionally cover the light gaps . Nice video, well done bro. PS lightly mist the liner before peeling that will cut down on static electricity , dust buster😂

[@manifiesto5287]

Good job bro

[@briantomazi9491]

I want to DIY tint a new tractor would it be easier and turn out better if I remove the doors and windows I have replaced rear, side quarter and door glass on my own tractors

[@manifiesto5287]

Nice 👍

[@ogmelo9547]

How did you shrink the film? Did you roll the film out vertically and shrink it horizontal?

[@windowtintinginstitute5578]

Yes

[@lazyjdfarm]

What film did you use?

[@gentlemanfarmer2391]

Do you have patterns where you can cut the tint out and ship it, I can't find anyone in NC to do this type of work? I have a Kioti RX cab tractor, i can't imagine there are many designs for tractor cabs.

[@windowtintinginstitute5578]

Sorry I do not have patterns

[@Shamrock365lawn]

What do you charge to do this? I have this exact tractor.

[@CLUB-th7pp]

Tinting one tomorrow. No shrinkydink?? Hhhmmm what kinda film my friend. The light gaps. I know it’s a hassle but I got farmer customers that expect no light gaps. As do I . I know it’s a hassle but I go ahead n pop out the doors ( which is a pain) I remove all door hardware n when I’m done there no light gaps. 35 yrs I been doing this and I hate that it’s the only way to do one really right. But hey I don’t know what u charge but we get $1500.00 to tint most tractors.

[@windowtintinginstitute5578]

1500$ is what I charge for most tractors too . The bolts will twist or wrinkle the film once the glass is reinstalled . So have a little lite gaps or wrinkles .

[@CLUB-th7pp]

@@windowtintinginstitute5578 heat gun. Heat it up . Heat up an area about a foot around the area . That’s what I do. I’m sure u have ur lil tricks to.

[@Dave_the_Detailer]

Taking off the hardware is the only way. Cutting reliefs looks bad

[@thuhaze5946]

We’re are you located? I have the exact same Tractor.

[@windowtintinginstitute5578]

little Rock , Arkansas

[@duaneharriss9097]

Where is your heat shrink process at bro didn't see it