How to use the creality cv laser

[@gregvanniekerk9545]

Thanks for all the info, one question please... where does the 1.6w module plug in on the cr6 se.

[@manojmahanty4472]

Nice installation🎉🎉

[@XempegeX]

Is there any way to save to project instead of starting from scratch each time? The laser part of software is really lame, it asks me for a save, I do it, and when I try to open it's empty! :(((

[@AlexOscarsWorld]

should you use air assist and or the honey comb?

[@3DPrintingStorecoza]

It is not technically necessary, but air assist helps improve the detail of the cut, and keep the lens cleaner for longer, on that same note, honeycomb bedding helps not leave scorch marks on the back of cuts and helps you avoid engraving whatever backplate you use, in this case the bottom of the printing bed.

[@AlexOscarsWorld]

That helps so much! Also can you plug the 10w laser directly in to the ender 3s1 pro without using the control box or only the 5 and 1w?

[@3DPrintingStorecoza]

@@AlexOscarsWorld I don't have an answer for you yet, but our guys will be testing it out today to see if it is possible

[@AlexOscarsWorld]

Hi just curious did it work?

[@3DPrintingStorecoza]

Our technical team couldn't get to it last week unfortunately, they said they will try to get to it today, so I will let you know later if they do and what they figure out.

[@Norain1992]

does it work in combination with the creality sonic pad?

[@MitchGurowitz]

I was told it does work with the Sonic Pad, I’ve yet to install either the pad or the laser as of now (As I’m having too much fun with the K1 Max and Bambu x1 Carbon, but I’ll get to it over the holidays).

[@3DPrintingStorecoza]

It does indeed work with the Sonic pad, here is a video link on how to set up the sonic pad and laser: kzbin.info/www/bejne/l5SWaJqOqamqmqM

[@gabrieliface1350]

hi, on your video 4:54 you not have on there LASER options, on 4:56 you have there options LASER! how i can swith to the Laser please, I not have options there for LASER like you on 4:54 :)

[@3DPrintingStorecoza]

Maybe try reinstalling the software and make sure that the Ender-3 S1 is selected as the device you are using, the option to select the laser should be there by default

[@averypenegar3758]

@@3DPrintingStorecoza you cut the video from not having the fdm and laser tabs, to magically having them pop up. I reinstalled, it does not pop up by default. What did you do in that section you cut out to get the laser and fdm tabs to show?

[@averypenegar3758]

@@3DPrintingStorecoza hey just tell him to add ender 3 s1 laser that's right beside the pro profile in the drop down, it does not pop up by default

[@MarceDeArmas]

@@averypenegar3758 Thanks a lot, this is the solution...