How to wire two Proximity Sensor in series for cnc plasma anti collision Torch breakaway.
Пікірлер: 13
@JackInTheShop Жыл бұрын
My anti collision is have the torch head loose. So if it hits something it slips out of the mount rather than braking off. LOL You have a nice setup there.
@rosswoolley2854 Жыл бұрын
Thanks Jack.
@RustysMetalCutSignsDesigns Жыл бұрын
Ross, do you find the anti-collision head 'colliding' with anything very often? I don't have an anti-collision unit on my table and I've had my torch tip drag on the metal a few times but not done any damage. Are they worth installing???
@rosswoolley2854 Жыл бұрын
Hi Rusty, My last video CNC PLASMA CUTTING TREE OF LIFE WITH STAINLESS NUMBERS FOR THE APARTMENT when i cut the numbers it collided with a flip up, restarting the cut might be a problem cause with Masso it restarts at the beginning of the the cut. I think it is worth having for the price of a machine head being replaced is expensive. "I have the mount half way down the machine shaft now and that has eliminated all the wobbling when cutting now. Here is were i bought mine. www.aliexpress.com/item/1005002309902905.html?spm=a2g0o.order_list.order_list_main.252.21ef1802Vt44CO
@ghanshamjadhav36810 ай бұрын
Hi Ross I put new NPN ,2mm sensing proxy sensors for plasma touch off Broun wire masso +v24 power Blue wire is connected to masso GND Black wires on end I put 5.6k restior and restior connected to masso input pin 7 ,plasma touch single . did you put 5.6 restior on end of black wire ( load ) ?.for plasma tuch single Still my masso G3 plasma not working.
@rosswoolley285410 ай бұрын
No resistor on the black wire.
@ghanshamjadhav36810 ай бұрын
Means my wiring of plasma touch singles still wrong . Is it ok to remove restior and put black wire load ,to put directly on masso G3 input pin 7?
@rosswoolley285410 ай бұрын
@@ghanshamjadhav368 Yes
@ghanshamjadhav36810 ай бұрын
Hi Ross I put new air regulator And now I used flotting head and micro switch yesterday I did a cutting trail still not working. I updated small videos Please check it on the forum. Thanks.
@shaneschuller251310 ай бұрын
So no more THC?
@rosswoolley285410 ай бұрын
Still have the Proma 150 THC it sits on the side of the plasma unit and the wires run to the Masso controller. Thanks for your question and thanks for watching the video.🙂
@shaneschuller251310 ай бұрын
@@rosswoolley2854 Thank you 🙏 and thank you for sharing your knowledge 🙏