How To Wire Your Stepper Motor

[@3DPrintingStorecoza]

If you have any other questions about this video or any other one of our videos, feel free to leave them in the comment section below

[@technybirdsstemtoys5887]

Good information about pairing of stepper motors ,Thanks

[@rustyshacklferd1829]

MKS CD Current Expansion Board

[@houseofsolutions7105]

So when it comes to Stepper being connected with plc, all arduino, cnc shield and breaker board is omitted right?

[@jjlopez8696]

What is the purpose of the 24VDC going into the CNC Shield board?

[@jjlopez8696]

How do you set the jumpers on the CNC Shield board? How you anable the CNC bord?

[@olanordmann7836]

Im trying to find something on these breakout boards. I have been googling them for an hour now. Where do you buy them? Can I use the stepper drivers I already have on my cnc shield?

[@rustyshacklferd1829]

MKS CD Current Expansion Board

[@billkahler886]

Where do I purchase the break out board? I cant find it on Amazon

[@markg3040]

I couldn’t find any either so I made my own, let me know if your interested

[@markg3040]

You’re*

[@jjlopez8696]

Where did you set the jumpers for the steps?

[@jjlopez8696]

No reply?

[@wisdomonsobo9346]

Where can I find the breakout board

[@jasonfoley2954]

I’m looking for those also .

[@wisdomonsobo9346]

@@jasonfoley2954 actually managed to get it working without the board

[@DeanosRides]

Aaaaaaaaaaaaaand what is cost of this DIY system? Looks fun... 🤣🤣🤣🤣

[@3DPrintingStorecoza]

It depends on you would need exactly, you can get larger and smaller stepper motors, different drivers etc. This exact system would put you back about R2200

[@DeanosRides]

@@3DPrintingStorecoza Thanks. Always wanted to give a CNC a spin. I also heard of some conversions available for the Ender 3 printer to convert to CNC. Something else you guys could look into and MUCH easier to setup.

[@3DPrintingStorecoza]

Will do so! Yea, this video is for those who want to build their own custom rigs but aren't too sure of the wiring and components. If you get a Cron Craft, most (Nearly all) of these steps have already been take care of

[@DeanosRides]

@@3DPrintingStorecoza OOO! And while you at it, do the Creality Laser engraver attachment! That also looks interesting!