how we make our straps and belts quick b-roll leathercraft

Hi guys here is a short video about how we make our straps and belts
check out our website: qcrafted.com
thanks for watching there soon will be more,
subscribe if you wish to see it

[@tholangmojela4455]

I love your work. Much love from South Africa ❤

[@qcrafted]

Thanks!

[@lightblue728]

good job

[@qcrafted]

thanks!

[@michaels2208]

Did you make the mods on the arbor press? Can you use it with dies? I'm looking into a press currently. Money is a thing, so trying to find best, least expensive option.

[@qcrafted]

I have this press m.kzbin.infofNOAIwVJHiY that cost about 100 GBP but these hand presses and arbor presses aren't strong enough for die cutting, just hole punching and small die like loop for belt or 2cm by 2cm square I was thinking about laser cutter it would be cheaper but then is not as quick as die cutting

[@qcrafted]

I was thinking to modify the hydraulic press like they use to take out the bearings, but when I start counting cost of steel it workout nearly half of cost of clicker press...

[@michaels2208]

@@qcrafted that's what I just found too. The vevor one, even the biggest, would probably be about the same or cheaper. Then that is meant to be a press, not modified.

[@qcrafted]

Yes. But I watch some videos about Vevor and they also got capability only for smaller dies, perfect would be clicker press but is expensive and weights around 1tone. I think I will go for laser cutter at some point, at least on it you can also make stamps from perspex, and few other useful things