HPI Vorza S Flux Truggy - Draco Upgrades / Front and Rear Chassis Braces (Part4)

[@00Spynall00]

Can't wait till i can get my hands on a set of these 👍

[@kylarstern7627]

Great video my friend, thats the most I've ever heard you speak! Your parts rock my dude, shouldnt be long before you get a siese and disist order from HPI, your putting them to shame!!!

[@kylarstern7627]

To anyone that will listen: The stock mount only runs into the brace on 14T and lower, everything above that is clear.

[@taffer74]

Happy to see this progress, doesnt look like its too much longer to wait!

[@dracoprecision]

Probably still quite a while. I will make some changes to the towers and motor mount set. But I’m happy with the progress so far!

[@bingcringing]

very stiff setup, those parts look cleaner than some genuine hpi hop ups 👏

[@dracoprecision]

Thank you! The final parts may look different. There may be a raw aluminum look.

[@JimmyDaval-u4x]

Great job my friend!... HPI GUYS AND FANS GO GET THEMSELVES THESE UPGRADES !....

[@dracoprecision]

Thank you!

[@taffer74]

Any chance of making front and rear skid plates (metal or plastic) they are getting harder to find, also a clear chassis protector with precut holes would be great

[@dracoprecision]

Yeah I could do that. Maybe some 6061 plates front and rear and a chassis protector.

[@Ashkoos]

Quick question. What shock springs do u use for this truggy? The original ones suck

[@dracoprecision]

Sure thing! I use Kyosho springs and recommend the following: IFS-002-815 / IFS003-915 / IFS002-8515. It is best to stay with springs 80mm long as once batteries are installed the vehicle sits quite low. Hope this helps!