Hydraulic Clutch Overview

Robert shows the steps of setting up an American Powertrain Hydramax Hydraulic Clutch
www.americanpo...

[@mikestannard7128]

Absolutely one of the best after market kits I have seen. Everything you need is enclosed my contact Greg Fetner was extremely helpful. I f you are considering this conversion look no further. I installed on a 1963 Falcon with a 351 and a 5 speed

[@gc3022]

1992 chevy k1500 nv4500, changed master and slave cylinder, and clutch kit, throw-out bearing, pilot bushing, flywheel, clutch and pressure plate, blew out 2 slave cylinders, first one split on casing (plastic), the 2nd (Luk) one gave out replaced seals from the plastic one, built pressure, lasted 1 drive then gave out too, haven't seen where it's leaking from yet, any ideas, or any recommendations on a heavy-duty slave cylinder

[@danieldonahue3293]

great info...math and display...very clear science...thanks

[@raulmendoza1685]

Good info: would this set up work on a 1052 Chevrolet fleetline deluxe car with 4 speed Muncie transmission ?

[@BKMDano17]

Setting up a tremec behind a 460. Would like to do this but I hear it's almost impossible to bleed this set up. Thinking I would be better off with a slave cylinder??? Thanks for the video

[@harrygearhart4520]

Is a hyd. conversion available for the SM 465 truck trans used in Chevy trucks?

[@astm1554]

Will this work on a '69 Mustang 428 CJ with a four speed toploader and long tube headers?

[@AmericanPowertrain]

Sure does

[@bassmasterbri]

I think a hydraulic system with an external slave cylinder with a adjustable pushrods and stock self centering style t/o bearing is a more reliable setup....😎

[@19jody72]

What clutch master can be used with this? 3/4 bore..7/8 bore???

[@isaiahfelts8799]

I needa know if I can put one of them five speeds and if the imput shaft will go all the way in

[@isaiahfelts8799]

Is the crank on the Oldsmobile 455 different for an automatic or standard

[@bananaman2184]

yea you need to drill a hole in the crank for a pilot bushing

[@andyashcroft9316]

did you really say washers????