Hydraulic Cylinder Rebuild Haulotte Bil-Jax 3632t How I did it

[@mikesrandomvideos]

thanks for your comments and likes

[@mikesrandomvideos]

lift still works good.

[@obslife1985]

Got a question for u sir if u have the time. My dad and I have a lift just like this on you worked on same model and setup anyways went to set the outriggers yesterday and it set the lift but was setting it up not level so I was fixing to recalibrate the lift and when I went to retract the outriggers they wouldn’t retract at all but the motor was engaging so we had to Jack the lift up and take out the pins in each leg to haul the lift back home and when we put them back together now it will retract and extend but it’s very slow like really really slow and it’s like it doesn’t have enough pressure. Was just trying to pick your brain on what might be wrong. Any advice would help

[@mikesrandomvideos]

did it end up being the pump?

[@obslife1985]

@@mikesrandomvideos yes sir it was the pump and we had to replace one of the sensors on the front outriggers . Now when we set the outriggers down one of them will go down first fast before the other 3 which I think might be air in the lines but don’t get me lying 🤥

[@obslife1985]

@@mikesrandomvideosthank u sorry for your advice and help I really appreciate it . U saved us a lot of money

[@mitchsmith5759]

Did this take care of your outrigger drift.

[@mikesrandomvideos]

yes the cylinder was bypassing. this is the wear point. I would start there if your having that problem.

[@blainecelestaine4543]

This is good stuff

[@HydraulicService-tf7ti]

You should Never Never Never use air to push out the rod and gland assy!

[@mikesrandomvideos]

done a few that way but yea you need to be really really careful and not too much pressure...Otherwise it can be really dangerous.