Hydraulic System - Bleed Air

[@TheNordmo]

Hello. What was the cause of this repair? What symptoms, before you did anything, I lost the power of the clutch. Have cleaned and refilled the brake fluid and vented the system. But there are no air bubbles in the return to the container on the handlebars ...

[@ianspooner2250]

What if the system has a reservoir tank and gear pump that operates a dumper? Will any air trapped leave through the reservoir breather.

[@williammason4788]

Good afternoon: very weird day with my JD 790: first front bucket wouldn't lift. Then 1st gear became reverse, and reverse became first gear! Then throttle didn't work. Turned it off, then back on. Shifting seems ok, andhtrottle works. All hydraulics quit - front end loader, rear three point hitch, and power steering. Has dual hydraulic pumps but I am afraid to just pull it off. Something drives both pumps. Help please!

[@akasvaltd3940]

Please tell, if hydraulic pipe fail at higher elevation

[@bigsmiler5101]

Whoa! I thought I grasped what was going on until the end when you removed the hoses and put the caps back on. IF those hoses that you'd attached to the Tee-Fitting are from the pump, then how's the system going to run without a pump after you're done? It seems you attached (something) only for bleeding the air. AND where did the air go? You showed no air coming out when you released the fittings--only fluid came out. Finally, what's a "slave cylinder"? What kind of system do you have there?

[@DyslexicLunatic]

There is no master cylinder t-fitting, nor is there a hydraulic valve. Only a fill with a rubber plug that has a pin hole in it.

[@OHBINEY]

whats the size of the thread

[@howardrennell3286]

X