HYUNDAI KIA 2.4 GDI CYLINDER HEAD GASKET TORQUE SPECS AND BOLT SEQUENCE

[@AutoRepairGuys]

⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzbin.info

[@diyautosolutions1960]

Do you install the gasket dry or use sealant

[@QwertyQwerty-jq3cu]

Why did you mix torque patterns? Your first pattern was straight on the middle bolts a d crisscross on the end bolts. Then the second and 3rd time around you crisscrossed 1-6 the opposite crisscrossed 7-10. That's not right! Torque spec is 17Nm, 35Nm, then 90* & 90*. You should do 2 35Nm patterns at the minimum because the gasket doesnt crush fully on the center bolts on the first pass. If you go back a d check them, they're only at 20Nm especially since you skipped the 17Nm pass that initially set the head bolts to the same torque.

[@donsaali8447]

OK

[@marionfarmer5308]

Video ain't doing no good you're not telling how many torque pounds you put on a torque wrench

[@forlife5737]

Youre not listening he just said it from nm to lbf ft.

[@bobclark9881]

Kude ti e serviza