I FINALLY Finish my Th400…. Tsi trans brake and rebuild!

[@funfun8095]

It's a lot easier if you put the forward hub in first, then put the clutches and steels in. Instead of fighting it. That's how I do it.

[@funfun8095]

You should also double the o ring in the case, on your filter tube. You're also using the wrong filter. That stock one you're using will restrict your flow, especially using a transbrake. You need the brass filter style. And you're modulator plug bracket is upside down. Hope it holds it in.

[@DanielsDesign]

I have not used it yet. I did double the o ring but don’t think I showed it. I need to go over a few things for sure now you’ve pointed them out. Thanks for saving me some trouble

[@funfun8095]

@@DanielsDesign Hope it helps. Better to fix it now, than later.

[@funfun8095]

If you haven't ran that th400 yet, I think you forgot a seal on the center support. You'll have issues. You left off the 2nd seal, which is correct, but I didn't see a 4th seal on it. You should have 3 total seals, 1st, 3rd, and 4th. You just had 1st and 3rd seal on it. Should also use solid Teflon ones, not just the scarf seal ones.