I Messed Up My Alignment!! C02 Laser!!

I messed up my mirror alignment so wanted to do a video showing how I messed it up and how I fixed it took me 3 days but got there in the end hopefully this may help someone else out enjoy!

[@maufimoraho5410]

Awesome video mate appreciate this

[@jppalm3944]

Amazing how far people will go to avoid reading instructions. This maintenance info readily available.

[@Weallneedapurpose]

I’m doing a shit ton of research on lasers before I ever buy one. Glad I am.

[@woodendayz]

Yeh mate research is key 👍🏽

[@Weallneedapurpose]

@@woodendayzthanks for making this video. I’m trying to really learn about the safety hazards, the maintenance, the extra things I need like the air assist for fires, the chiller and stuff like that. Any thoughts on what to research? What problems I’m going to encounter and how to best setup my station? Do you have a surge protector or anything special for power?

[@woodendayz]

Just research C02 lasers in general yeh you should have a serge protector on the laser itself iv been very fortunate with mine as I havnt had many problems at all my machine had been great I did the air assist myself using the ultimate air assist kit that I bought from Amazon and that made a huge difference so definitely recommend doing that

[@JP.Alonso]

There is a video on youtube with a guy using masking tape to align the mirrors. You have to check a dot in the center of each mirror and masking tape helps checking that dot.

[@woodendayz]

Hi JP, Yeh that’s how I aligned mine I went into it without doing any research and quickly found out the hard way what not to do, eventually got it sorted! thanks for watching!

[@wuzgoanon9373]

Did your adjustments make any difference with the power settings used to cut? You didn't mention whether you solved the original issue you set out to correct.

[@woodendayz]

Hi, yeh it definitely did make a difference I was able to cut my 3mm at 30% power with a speed of 12mm/sec and my cuts are now consistent across the whole bed where as before it would vary from the top left of the machine to the bottom right so the adjustment was definitely needed but I think the main thing is to keep the lense clean it’s surprising how dirty it can get I clean my lense and mirrors weekly now, Thanks for watching, Matt

[@dishatechno7793]

Nice 🎉🎉 video i am subscribe your channel ram ram

[@woodendayz]

Thank you! 😊

[@Martin-ll7jc]

Sounds exactly what I did then I did the research,like the cake rings

[@woodendayz]

Hi Martin, yeh it was definitely a learning curve for me but you learn from your mistakes and now my machine is dialled in perfectly and I feel a lot better about doing regular alignment checks and adjustments when needed, cheers Matt

[@Martin-ll7jc]

@@woodendayz going to do the air assist next just likes your other videos great channel pal 👍

[@woodendayz]

Thanks mate really appreciate that!! And good stuff it’s a very noticeable difference, sing out if you need any help!

[@ProfessorOfEconomics]

Was there a particular source you found especially useful when aligning the mirrors?

[@woodendayz]

Just a lot of research on google and KZbin no particular one

[@jppalm3944]

When all else fails, READ THE MANUAL. WHO WOULD TINKER LIKE THAT?

[@woodendayz]

Me 🙋🏽‍♂️ I would! 😆

[@jppalm3944]

@@woodendayz godspeed.