I Rebuilt My Polaris RZR 800 And Blew It Up Again In Under 5 Minutes

This video is all over the place. I had a bad time with not being able to find alot of the clips I made throughout the rebuild process. Anyway, It did end up running after the rebuild but that was short lived. It blew a headgasket in literally under 5 minutes of run time.
SUBSCRIBE!
/ @ramenbuilt6411
MY EBAY STORE
www.ebay.com/s...

[@dillonlagrow861]

The head bolts are torque to yield, so they stretch when torqued, you have to use new ones every time you pull the head off.

[@street_wise_gamgee]

if it blew the head gasket right away check your case and head for warpage.

[@alexgomez3624]

looks like oil pressure relieve valve got stuck causing to much oil pressure

[@briancooper-co1wd]

What brand of parts u order and were u order them from?

[@prorideparts2646]

Install the pressure guard oil presure control valve to solve any oil pressure problems

[@hc_elite6846]

what wheels are those?? I might be getting a 800!!

[@keithchappell454]

Ramen, what lift setup you have on yours. I"ve been looking at something not to high and yours look perfect.

[@ramenbuilt6411]

It’s the stock “s” suspension with the shocks tightened up a lot. I wouldn’t recommend as it rides horrible. I’d recommend going with a 2 inch or so bracket lift.

[@CB_ChaosLove]

Right on dude, keep it up, I’ll be watching 👍

[@ramenbuilt6411]

Hopefully will start getting some stuff done in a week or two when the gasket get here🤞🏼 thanks for watching!

[@ericstyer2890]

So the 900 plastics fit? Cool car dude

[@ramenbuilt6411]

I didn’t put them on so I’m not sure what goes into putting them on but yes they definitely can fit!

[@red1ton975]

What lift is that sits real nice

[@ramenbuilt6411]

It’s just the stock 800s suspension with the coils tightened up a lot. It rides terrible as it is.