I review the Makita HS0600 270mm electric saw.

[@crazypete3519]

@botanical1968 wrote: 4 months ago The reason the saw is binding is you have it supported at both ends. When you complete the cut the timber pinches the saw and kicks back. Have the large section supported and the short section unsupported, that way when you complete the cut the short section will peel away rather than pinch the blade.

[@chrisbotham6460]

Put the body of the saw on the longer section so the offcut falls away as it’s pinching the back of the blade the way you were doing it

[@enggwahaj]

Just a tip for using big circular saws. always cut in such a way that the motor side of the circular saw will sit on a heavy piece work piece, so when you reached at the end of the cut, the saw will ended up siting on the heavy piece, prevent blade jam or kick back.

[@W1tch3R_85]

It's amazing to see. Had the kick back on my small one too, which broke 2 days ago. Now the 0600 is ordered..

[@yevgeniyshawyer2767]

What I can see is a lack of experience.

[@peopall100]

Always cut off your overhang and let it drop. Usually an off cut. So double the blocks up next to each other. And cut letting it drop rather than see saw and pinch your blade. This will stop the kickback. Don’t middle cut between 2 props like that. Just avoid that and never be directly behind any circ saw anyway can see sights on blade cut or guide from side on with this tool and if still kicks because something goes wrong you have a safe position by habit. Happy work to you 🤙

[@JorisDeRuiter-nu8qj]

There is tension in the wood wich makes the wood bend to eachother also the way you position your wood makes it fold together so the blade will get stuck in between.

[@round69]

I think tension in the wood becomes an isue when you cut along the direction of growth. Cross I have never experienced anything like that,.but maybe,. and 2. point,. i just saw it coming when he started,. 😬,. I hope he reads the comments,.

[@tymbian]

A painful watch. Let the off-cut fall as you cut so it doesn't bind.

[@rascus555]

Going to buy one, but.. As below, hard to wach, need two supports on to ends of two offcuts.

[@АлександрАлександр-ц8ч]

What was the price of this saw? Thanks!

[@botanical1968]

The reason the saw is binding is you have it supported at both ends. When you complete the cut the timber pinches the saw and kicks back. Have the large section supported and the short section unsupported, that way when you complete the cut the short section will peel away rather than pinch the blade.

[@W1tch3R_85]

252€

[@АлександрАлександр-ц8ч]

@@W1tch3R_85 👍

[@Chris-vc1dh]

I want to make this saw into table saw as big blade

[@Steve-vz3ud]

These saw,s always have a bit kick back.Mite have to buy a Drop saw .safer

[@TheDieyet]

This is a man's saw , not for boys.

[@maga7596]

мдааа , для начало научись ручной пилой пользоваться....

[@emilhristov2308]

Good that he survived that test :)