iCarsoft i902 Vauxhall ABS Warning Light Diagnose Reset OBD2 Tool Service Stabilitrack

The iCarsoft i902 has been replaced by the much better OP v1.0 as shown here www.diagnostic-world.com/pages...

[@Boycie350gt]

This video has helped me thank can I ask on the wheel where the problem was did u have the sound like the brakes was stick slightly on when edging forward in the car

[@peternigold798]

Thank you legend!

[@harwoods11]

Did you find the sensor by driving the car and checking the sensors via scanner or by jacking up each corner and spinning the wheels?

[@ThorsTreasure]

Will it tell me which hub bearing is fecked

[@ItsFriscoBaby]

So you're reading the codes on a 7 year old car and it's not quite up to date enough to show the code info. The car will probably be bean tins in 3 years so when will it be updated?

[@terryleppert386]

Plug my scanner in see if you can see DTC cods and clear them watch video I sent you it will go of on dash strait away if it stays on its a wire on break pads.

[@chrisreeves8402]

Hi I've change wheel sensor on mine when I accelerate the traction controll blinks goes off car lacks power and abs brake starts pulsing ive plugged in no t fault any idea mate been doing my head in for mounths

[@imhim0k_]

Hi my car got same problem but it doesn't start

[@andrewhooper4241]

Just happened to mine did you get to the bottom of it . I had to press tc button to make the car start but did have loss of power also

[@kojones9086]

@@andrewhooper4241 hi did u sort it my car doing Same

[@newry123]

bought this for my 2013 insignia had ,service vehicle soon message ,this scanner showed no faults ,had to take to garage 2 glow plugs bad, few months later car going into ,limp home mode, plugged scanner in still showing no faults,,not impressed

[@jonathanthompson6783]

o ring gasket in the sump?

[@newry123]

@@jonathanthompson6783 could you tell me a little more about the oring/gasket in sump,,,cheers

[@jonathanthompson6783]

@@newry123 my car did the excalt same thing service vechile soon and went into limp mode but it also had low oil pressure light show on cold start so it might not be you're problem but for me it was the o ring gasket in the sump its a wee peice of plastic that had hardened and should be bendy it caused my car to do that because of a leak it had caused, got it replaced and its fine now.

[@jonathanthompson6783]

I have insingia 2012

[@newry123]

@@jonathanthompson6783 that’s great thanks