Incomplete Pulse Motor Demonstrating Some Serious Voltage

[@anthonyjousse3020]

The Switchting out put commutation and thé Switching coil pass the core IS very importante . For dirack water .

[@sandysmagicmix]

How did you cook the axial flux coils? What a shame they looked so perfectly wound!

[@11Sam11]

To be honest i have no idea. My guess there might of been a kink or a split along the wound somewhere within the layers when winding it. Such a shame indeed

[@anthonyjousse3020]

The Switchting out put commutation and thé Switching coil pass the core IS very importante . For dirack water .with mecanical silver Switchting if you give a good Time and the good résistance,you have 2 kV volt ac per coil .1 wire .4000 feet awg 41 .

[@anthonyjousse3020]

@@11Sam11 it s m'y ampli .41 awg 4000 feet but you dont need ... For straight commutation of dirack water.

[@anthonyjousse3020]

@@11Sam11 the only effective power that interests you is the var the rest will make you lose and to have the var in series or in parallel you need the efficient switching a robert adam. why because it removes the drag from your core, activates the Lenz reverse, and gives you a gain multiplied by 4 or 5 due to the pressure exerted, a coil does not magnetize in a closed loop. you need a contact so that your coil train magnetizes.... while your motor is running....and the more contact there is, the more voltage and current there will be.

[@anthonyjousse3020]

@@11Sam11 the only effective power that interests you is the var the rest will make you lose and to have the var in series or in parallel you need the efficient switching a robert adam. why because it removes the drag from your core, activates the Lenz reverse, and gives you a gain multiplied by 4 or 5 due to the pressure exerted, a coil does not magnetize in a closed loop. you need a contact so that your coil train magnetizes.... while your motor is running....and the more contact there is, the more voltage and current there will be.

[@doubleooh7337]

just gotta figure out what to do with the output, but you can change how the coils are connected to get a lower volt higher amp yes?

[@11Sam11]

Definitely. That's the main goal where i'm heading. Cheers

[@anthonyjousse3020]

You have a drag ... Only coil have a drag but you Switch off the coil you dont have a drag ,all coil .

[@anthonyjousse3020]

You have 500 v 2 kv per coil? No you dont are the best .please use a feritte baryum magnet ,you saturate the bedini core

[@11Sam11]

Luckily i do have large Barium ferrite magnet. Four of them.

[@anthonyjousse3020]

@@11Sam11 I also, among other things, suggested to them the idea for the negative resistance and the ringing... anyway, I'm happy as a boss... you must be able to find this effective electrostatic switching without a capacitor... you won't see it otherwise. .. I arrive without the earth and under LED load 2 ampere... and I still have the 2 kv. you have to find the perfect contact... no need for electronics and company it's crap find the switching a adams, open the coils when they are all in phase in front of the magnets and close... 2 degrees further... further and move it to what you find

[@anthonyjousse3020]

Sam learn me give me your Messenger

[@11Sam11]

Your advice of the lower rotor being more powerful has help greatly. I'll take any advice i can get. Thank you brother.

[@anthonyjousse3020]

@@11Sam11 hou have s nap .. c ?