Infiniti G37 Rear Brake Caliper Troubleshooting and Replacement

Brake Caliper was bought on eBay
amzn.to/3U5Fgpr - Rear Rotors and Pads set
amzn.to/3GIV5iW - Rear Pads Set
amzn.to/3ExCqnr - Caliper Piston Compression Tool I used
amzn.to/3AFXPK9 - Crowfoot Wrench Set I used

[@1kzooki]

When you went to the other side of the car and it wasn’t moving it was like a horror movie props to you sir for doing the absolute best and showing every single step

[@PZPal]

Thanks. The repair took a very long time. I was very confused as to what issue was lol but that's what can happen what repair is done by a shady shop or a clueless DIYer who forgets to put back same amount of bolt or washers that were removed lol

[@bromikke4304]

This was excellent. Totally understood what to do from start to finish. Took the time to figure out that it was for sure a caliper gone bad straight through describing the importance of the washers onto keeping fluid full as you remove and install. I wish all KZbin mechanics would learn from this video while teaching how to "Not" just assume we already know what to expect or to look for as we go. TY!

[@PZPal]

Thank you for your nice comments, that definitely helps me keep going with DIY guides

[@1kzooki]

Was wondering if cleaned the wheel hub or not but yea okok 9:49

[@vanii241]

To Get Those Bolts In And Out I Think You Just Have To Turn The Steering Wheel

[@PZPal]

If it would be front yes, but these are rear :)

[@fairlifelover69]

do you know what size those rear caliper bracket bolts are?

[@PZPal]

If I don’t mention it in the video then I don’t remember now, sorry

[@golfcon]

Great video and thx for crowfoot wrench set link

[@jaydens2756]

Does the car need to be on to bleed? Replacing both rear calipers today because one was seized, already did the brakes and rotors on the others

[@PZPal]

It does not need to be on to bleed. From what I remember, I decided not to bleed it because I quickly changed out calipers while the connector was leaking fluid, so I don’t think any air got into the system.

[@jaydens2756]

@@PZPal gotcha that makes sense so even when you compress the piston no air got in? Or is it because you pre filled the new caliper as well?

[@PZPal]

Yeah, I normally prefill them and then quickly change them out. That way amount of air that could get there is very minimal. I never had issues with that way of installing them, but I am sure proper way is to follow up with bleeding procedure.

[@brandonstewart1053]

why red locktight no mechanic i know uses red locktight sounds like a horror story if you need to remove again