Injectors Part 1- Foam Latex

"Foam Latex for Makeup FX", will always remain a staple in the film industry. Learning proper procedures when working with Foam latex , Silicone & expanding Polyurethane foams, is a must for all makeup lab technicians. Join Steve LaPorte for his breakdown on Foam latex injector design & function plus a DIY approach to building your own. This is part 1 of a multi-part series on using & creating injectors for all forms of materials used in the makeup & effects industry as well as for the Cosplay & Halloween enthusiast.
Check out the SWANLAKE 1500cc, Fluid Extractor on Amazon, a.co/d/8QmlQB7
Model Pro Polyurethane casting resin on Amazon, a.co/d/8fCCWw9
Acrylic Pipe Clear Rigid Round Tube 86mm(3 3/8") ID 90mm(3 1/2") OD 18"
on Amazon, a.co/d/4j2Oews
Use my affiliate code, FACEMAKER30 , for a 30% discount on all subscriptions at The Stan Winston School, Click below.
www.stanwinsto...

[@kittykittysoftpaws]

Very neat, rhank u 👏👏

[@ChristineARose]

Sometimes making the thing, to make the thing, is as much fun, if not more, than making the Thing 😁

[@gfx8391]

was the resin TC-1630?

[@make-upmcgyver2812]

I used 1630 or Repro. Pretty much the same.

[@gfx8391]

@@make-upmcgyver2812 awesome thanks! good job on the SW course, I'm not a fan of the createx wicked silver though, have you tried allclad?