INMOTION V10 Electric unicycle Disassemble video

Produced by China's GREEN FASHION, pay attention to us and more videos will be watched later

[@michaelneumann3695]

What a soothing voice and music. Its like a meditation video. :D

[@donkeydem2824]

Thank you! My V10 gets here tomorrow. 😎👍

[@wikr757]

I can see the motherboard dismount is not from disassembly topic ))

[@nandepehua]

Hola Gente o "verde Fashon"... tengo un Inmotion V10. Al caerme una un recorrido, la ASA me quedo trabada y ABIERTA. ¿Saben como se desarma la misma para poder destrabarla? Hello People or "Green Fashon" ... I have an Inmotion V10. When I fell a run, the ASA got stuck and OPEN. Do you know how it is disassembled in order to unlock it?

[@AndreiPetunin]

Reassembling it is more tricky

[@honeysteve1803]

Fortunately, if you just change the tire, you don't have to take it so much trouble.

[@G.SpotFPV]

very nice video, is the battery a 20s4P ? Where does the fan take the air from?

[@honeysteve1803]

24s,4p

[@user-jb9to6nw5m]

Hello, at 45% battery Inmotion v10f says "Please repair", enables red lights on sides and lifts pedals, when I turn v10f off, wait 10 seconds it works fine for few minutes and turns off until connected to the charger. Is there anything I can do to fix that? Thank you in advance!

[@LeandroLoan]

Is it possible to buy just the red wires?

[@DreiSkins101]

My INMOTION v10 shows no indication of power after installing new motherboard. What could be the problem?

[@torielzagorodniy8429]

How to check the power button?

[@eduardovidal9664]

Hello how are you?, I want to know if is possible to change the battery of v10 and put the battery of v10f I want to know if it is going to work

[@michaelneumann3695]

I assume the software in it would still think you have the same battery so it might be glitchy. But dont know.

[@torielzagorodniy8429]

Got hit by rain

[@MrSzaroczek]

There is only one tricky moment in opening this wheel, for which I was browsing it which is taking the lid off the three catches and that exactly sequence you cut off! That suggests you struggled with it and couldn't do it professionally enough to show it to the public; shame on you and on the manufacturer of this wheel!

[@zackjohnson9387]

yea i’ve been trying for 2 hours no luck

[@vaivendo9022]

Olá,Very good,,plis, por favor me faz uma doação de um aparelho deste,por favor ,,no Brasil é muito caro,,,