Installing a bandit 1200 cylinder head

[@theranm3389]

Thx for your advice, my dad is helping me but it's nice to know how to actually do it😊

[@awiserbud]

Nice vid, just about to tackle the front oil return pipes, handy to find out where the timing marks and tensioner are. Informative without blabbering on about non-important stuff, just how YT vids should be .

[@leemarks8026]

Hey , I’ve skimmed the head I’m put on . Did you use higher torque setting ? What torque did you use? Thanks

[@EliseuCorrona]

Hello budy, how are you? Out of curiosity, what engine oil do you use and how often do you replace it? I noticed that the camshaft is very clean. Sign that perhaps uses a good oil.

[@RingTuned]

I run rotella to 15w40 in it now changing every other weekend but that cam has 175000 miles on it using amsoil metric bike oil changing every 8000 miles

[@EliseuCorrona]

@@RingTuned thanks for your answer. 👍

[@natanieljames1026]

Hey do you live near Michigan I need new rings on my bike but I don’t trust myself to do it

[@RingTuned]

I run a shop called 57 Motorsports in Tuscumbia Alabama

[@curtischarles1013]

Quick question bud head gasket base does it sit between the bottom end and the head gasket i need to replace my head gasket but not sure if in need the base gasket aswell cheer

[@RingTuned]

If you don't remove the block you don't need a base gasket

[@dboyyarris4811]

I changed my oil and filter on a 600 mk1 1997 bandit now the oil light is on permanently. Any ideas on what it could be?

[@RingTuned]

Somehow you have the wire running to the oil pressure switch shorted to ground

[@dboyyarris4811]

@@RingTuned cheers buddy I'll have a look at it.👍 I had oil pan off twice looking for a blockage 😆.

[@austinmetcalf6212]

Will you do one on clutch set ups amd stack height 🤔

[@RingTuned]

I don't measure stack height honestly. I'm still on a hand clutch so no real need to be that accurate. I have a stock basket with OEM steels and fibers I swapped 1 thin steel for an additional a thick one. I have 2 heavy diaphragm springs and a mtc single stage lockup. My busa has the toruqe modifier welded and 3 brocks xhd springs with 3 stock springs.

[@cowgirl962009]

Thank you

[@DoneRightBicycles]

What cams are you running?

[@RingTuned]

Gsxr1100

[@DoneRightBicycles]

@@RingTuned what year?

[@SuperMetin5]

same technique on a bandit 600?

[@RingTuned]

Yes sir very similar

[@SuperMetin5]

@@RingTuned cheers bud