Installing a Pro Stitcher Lite Flexi Rack on Handi Quilter Loft Frame for Moxie and Simply Sixteen

Tips and techniques for installing the Flexi Rack track for computerised quilting using Handi Quilter's Pro Stitcher Lite. The Loft Frame needs a blue flexi rack to be installed in order for the computerised carriage to be driven by the machine using the X axis.
In the video Liz shows how to install it using some templates. The front template is 15mm deep. The side templates are 15mm from the front track and 2" in (I know...we do both in the UK) from the end of the frame. The holes are 14mm apart to the centre of the screw hole.

[@kaycooper8001]

Thank you!!!

[@PinholeQuilting]

You're welcome!

[@PinholeQuilting]

@kaycooper8001 you are welcome!

[@lisamayfield5251]

I so needed this video! I’ve been using my Moxie since June 2022. All has been fine until one day the motors wouldn’t engage - only simulation. I took machine, carriage, and iPad to dealer. They said it was the bc the thread tension was too tight. I’ve had tension issues since the beginning I got my machine carriage and iPad back today. Same problem. Motors don’t engage. Sitting in frustration I decided to check to make sure the gear and blue flex rack were aligned. They’re aligned but not touching. Like the carriage is about 1/8 inch above the track. I don’t know how this happened and can’t figure out how to fix it. Any ideas? I’m really unhappy with my dealer and probably won’t be going back to them.

[@PinholeQuilting]

If the spring that pushes the motor down onto the X axis is set too loose this might cause the issue. However I would talk to Handi Quilter technical solutions who could guide you through the issue. I'm sorry that you did not get a good response from your dealer 😔