Hi Paul I know you've now got the F Pace, but if you decide to install the Audison into your new car, no need to cut those frequencies as shown in your video at 10:38, as your mids are crossed over at 500/3000 anyway therefore they won't play those frequencies. Also 24 slopes most of the time sound a lot better than 12's. Also get a UMik to tune it properly using REW you will be REALLY surprised how great this DSP Amp can sound 🔊👍
@provolumekc38695 жыл бұрын
Great video. And very nice install. Well done.
@B15SDMDESIGNS2 жыл бұрын
Lovely idea with using molex connectors to tap into the main harness so it can go back to factory should you want to revert back to factory
@priwoznikableАй бұрын
So you needed to keep the factory amp hooked up? Looking to do this is my 2021 rr evoque dynamic
@Kapb193 жыл бұрын
Great video! Thank you for the info. So I’m looking add to amp for my Audi S4, did you find it made a big difference to your standard speakers? Assuming you didn’t upgrade your speakers that is! Also are you able to tune the subs? Thank you
@venkatpadala3484 Жыл бұрын
Hi Paul, Do you know which fuse and relay to check for Amplifier power. My F-Type amplifier is not getting the power
@re_ze88072 жыл бұрын
Hi I have jaguar f type 2016 I want to install santr look at gas door How to install that?
@TheWidowMaker. Жыл бұрын
So, you made a custom loom to go from the meridian amp to the audison back to the meridian amp?
@paulcalvert5425 Жыл бұрын
Yes, I cut into the loom for the front door speakers, feed those into the audison, and then took the audison output back to the the door speakers.
@priwoznikableАй бұрын
Where did u get the connectors? Thanx
@MrRes1cue3 жыл бұрын
Can you check the output of your subwoofer channels. 50Hz test tone at full volume. I need the VAC ouput from the amp before your audison. My system is only putting out .8 VAC at .15 amps with a 50Hz test tone.
@paulcalvert54253 жыл бұрын
Hi John, I'd love to help, but to do that Id need to strip out the rear trim to get access. So its not an easy 5 minute job. Sorry.
@MrRes1cue3 жыл бұрын
@@paulcalvert5425 No problem, I figured as much. I decided to go the Audison 8.9 route as well for the fronts. Audiocontrol 1.300 will be on the Sub.
@MrRes1cue3 жыл бұрын
Did you have any issues with speaker loads? Did you have to use the Audison ASP speaker load plugin module?
@paulcalvert54253 жыл бұрын
@@MrRes1cue I didnt have any issues at all. I used the front mids as my main feeds.