Installing the Rugged Ridge Arcus Front Bumper. Is it worth the money ??

[@xandergamble1328]

You did good, my man. Nice, clear, fun tutorial!

[@itsadadlife]

Thank You !!

[@528lineboy]

This looks like the perfect bumper to go with my new winch on my 23 Gladiator that came with the crap plastic front bumper. Nice video. Thanks for sharing.

[@hgarbade]

Bumper arrives Friday! Just the vid I needed. Good job, Hiram.

[@zvency]

Hahahaha I was gonna ask how it holds up. Helps if i just check out the other videos haha keep up the great videos

[@itsadadlife]

Yea it’s been great, except those washers!

[@mr.blessing2155]

Can you do a update review? How are the fog lamps affected due to being recessed so far in?

[@itsadadlife]

I’ll post an update video for you in a day or two.

[@WreckedBrewery]

Love the look of this setup. When I'm ready to swap out the factory bumper, I also plan to do a winch and bull bar. Looks clean. Are you going to put anything below it like a skid plate or shield to hide those lower bolt holes and protect the front end any? Just curious. I thought about grabbing an OEM steel bumper with bull bar and steel skid plate below. Undecided but I like yours alot. oh, and to answer your comment in the video.... I have a Rubicon and it's plastic front bumper and plastic piece below too. I wish it was steel. Cheers!

[@itsadadlife]

Yes, I do plan to implement an under skid system, probably from Metalcloak and address that lower section at that time. In the meantime, other than looking a bit silly, it doesn’t hit on anything so it’s not high on my to do list.

[@elginwang1572]

Nice video. So there is no more OEM front skid plate after installing the bumper? Did you get a new skid plate?

[@itsadadlife]

They do sell an aftermarket skid that goes with this bumper. I planned on buying it but I put the factory skid back on for now.

[@elginwang1572]

Is that a 1/2 impact gun or 3/8?

[@itsadadlife]

3/8 DeWalt 20v

[@TheGraphicLibrary]

I have the same bumper setup. I wish they made a matching rear bumper for the JT.

[@itsadadlife]

The bumper is great. I will most likely be installing a metalcloak or motobilt rear bumper