Installing Tomei & GWR Midpipe On My ND Miata!

In this video, I will be installing a full exhaust setup. It sounds so nice and has a deep tone to it.

[@tincancars]

underrated as hell my bro got content :)

[@CortizMiata]

Almost spilled my water once you showed that hole 😂 This type of content goes hard, if you can maybe do a tutorial on how to install headers since i heard the o2 sensor is iffy … Planning to pair my isr straight pipe with a gwr header in the future !

[@chortomato]

Sounds NICE

[@713space]

I had to install a custom gasket for my Tomei to fit the GWR header. The Tomei is made for the factory midpipe with the O ring gasket

[@713space]

also I run a pop tune with the same set up, for the midpipe connector make sure you torque it like 80ft lbs LOL or else it will slowly seperate until its 2 pieces again

[@Mryataa]

That’s why the tomei doesn’t sit flush with midpipe

[@usiiotv5264]

Sounds very nice !

[@ruiyantang9222]

Just curious, how’s the car feel after the popnbang tune? Does it eat a lot of gas? And the hole on your exhaust really got me 😂😂

[@Mryataa]

ofc it eats a lot of gas lol but it's more responsive and feels better since it is a slow car

[@slottedpig2253]

Raise your car dawg LOL sheeesh that is gnar gnar. Also the sound is slightly different than it would be since there is a leak.

[@Mryataa]

That’s already raised 💀 i was lower before lol

[@migzahoy]

how do you get those crackles is it tuned?

[@Mryataa]

It’s tuned

[@itsmecolson3012]

@@Mryataawith what? Versatuner? I’m trying to research the best pop and bang tunes that also include a little more power for my nd2

[@Mryataa]

@@itsmecolson3012 yes, versatuner by fab 9 and i think its the only pops and bangs out there

[@jamiegarrod2237]

😂 you don’t know top fuel get a Tesla nerd

[@jamiegarrod2237]

Wanna add your exhaust that bad how many children you sa non3e