Installing Voodoo13 Front Upper Control Arms On a Q50 Redsport

The last piece to the camber puzzle is installed. This is a must if you want to preserve tire life and or if you are looking for a specific camber measurement for your build.
[Affiliate links]
Torque Wrench: amzn.to/3tPjN7Z
Mechanic Tool Set: amzn.to/3DNIfuP
Camber Gauge: amzn.to/3pSlUHD
Low profile floor jack: amzn.to/3DKm08X
Jack Stands: amzn.to/3EPzdyu
Music produced by: Colossal mind
#q50 #camberarms #redsport Support the channel and grab some merch here: zillafullboost.creator-spring...

[@ZillaFullBoost]

I'm trying my hardest to bring out detailed quality videos however, my 75 hour work weeks doesn't allow me to do so. I hope that the quick content I'm currently providing will entertain you enough until I get less work to focus more on YT. The faster I get the subs the closer I can be to do YT full time and get production in full effect! So sub and share my videos. Hope you all are doing well during these crazy times. Be easy and stay breezy fam. 😎✌ UPDATE: Took my car to the alignment shop camber was good, but the Toe was way off. Definitely need to go to an alignment shop after you install these.

[@BlaQBetty2018]

Excellent job, like usual. Doesn't SPL make q50 control arms?

[@ZillaFullBoost]

Thanks, yup they do.

[@gloglo1275]

Thank you for the video. I just installed on my 350z and it was sounding like something rubbing although everything was done right. Any advice?

[@ZillaFullBoost]

Not sure 🤔 Check over everything.

[@gloglo1275]

@@ZillaFullBoost Yeah I triple checked everything before I put everything back. I have to say for me it was a pain getting that installed. Those bushings kept on coming off and trying to align them. I just went to look and they are all okay but the one side on the driver side I guess those alignment pieces must have flipped so the one is the larger on the inside. Like I was saying it kept on spinning on me and popping off. It took me a long while to even get it to screw in. I had to remove my coilovers too because I couldn’t get the screws out or in with it so this job turned out to be a bigger mess. That side is not even making any noises at all. It was the other side which had the small piece’s inside as it should. At this point I’m debating of leaving it because that was such a mess and I don’t see how that would make a difference. It’s installed good.

[@gloglo1275]

@@ZillaFullBoost Well I went back and swapped it so it’s correct now. Luckily I was able to pull only the one side slightly off to allow me to switch the alignment bushings so now they are all facing the right direction.

[@bn4241]

How's the FUCA holding up? I'm thinking of getting them instead of SPL.

[@ZillaFullBoost]

Still holding up!

[@seanwells6570]

Are you awd? Do I need to take out the coilover or just the arm?

[@ZillaFullBoost]

RWD and coilover doesn’t have to come out.

[@gcalifornia7271]

Still have them on the car? How many miles have you ran them? How have they hooded up?

[@ZillaFullBoost]

Still on and about 35k miles. Solid piece

[@luisperez6572]

How much camber are you currently running on the fronts?

[@ZillaFullBoost]

-1.5